XT60i to O Ring Terminal Cable，More Than 8A，10AWG Extension Cable XT60i Female to O Ring Connector XT60i-f for Lipo Batterie (10AWG (10FT))

Works well for using LiPo battery to double power station capacity. Has correct, and required, signal wire pre-installed.

I keep these cables connected to my busbars to give my EcoFlow Delta 2 a charge from my house battery bank. Gives me a steady 200w charge rate. Just what I was looking for.

12awg wire insulated at 60C (which this product is) is rated for up to 20A of current. The Delta models from Ecoflow are limited to 15A of current on their XT60 port when using XT60i, so this is a perfect fit! Here you can see it connected to an AOLithium 100ah 12v LiFePO4 Battery which is plugged into our Delta 3.Works great and feels great. The leads leading up to the battery are barely wide enough to reach the terminals, so be careful if you have to split them at the insulation to make them reach. Luckily, I did not have to.

Well made cable for DC charging aLIFEPO4 portable solar power station. One of those gotta have if you need it items.Works well!

I have a Delta 3 plus and Anker F3800, using 48 volt 100 amp rack batteries the Anker charges at 1100 watts. Delta 500 watts. If needed I can add another cable to double input. The XT60i fits both because the center pin is blank on Anker. Cost of rack batteries are far cheaper, with higher capacity than buying extra batteries. Be careful not to exceed max voltages to not let the magic smoke out

This item seems well made. The terminals seem secure. Have not used them to charge my power station yet.

Worked fine for connecting external battery to EcoFlo Delta 2. (You get about 200 watts transfer, so it slowly tops off the EcoFlow)

Cables are thick 10ga but still soft and malleable. Worked perfectly for what I needed.