Titan FitnessPin and Pipe Safety Landmine Pivot

I really like these Pin and Pipe Safety Landmine Pivots. I found it works great with my Titan Viking Press and also with olympic bars. I use an olympic bar, one chain collar and a single chain attached to a loading pin at the bar's opposing sleeve to the pivot. Therefore, the bar's weight is only on the rack until it is lifted by user keeping the rack very stable. I wrap the chain around the barbell's sleeve before attaching the chain to the chain collar. This way the chain collar is only needed to keep the chain from sliding and not to hold the weight.I prefer a 60” Olympic bar with the Titan Pin and Pipe Safety Landmine Pivot if I use it with pin and pipe safeties set at the same height on both sides of the rack along with a chain collar, chain and loading pin. The 60” Olympic bar allows enough room to keep the weighted loading pin inside the rack while the Viking Press is at the outside of rack. This minimizes the length of the bar when I use the Titan Viking Press attachment. A full size 86" Olympic Bar also works fine with a chain collar, chain and loading pin however for space saving the 60" bar is efficient.

It's so simple, so inexpensive, and such a great product that you'd be foolish not to grab these. These fit over my Rogue Infinity pipe safeties, and it seems very practical just to leave them both on all the time. As I also had another new Titan product to try out, I immediately set these up for a chest press and a Viking press. I have had a regular landmine base for years, but as it's basically stuck to being on the floor forever, options are limited. These give me a secure pivot point at any height I want, and it's fantastic. I wish I would have had these from day one.

Product arrived very quickly very sturdy well built will have to adjust my power rack before I can actually use it.

Simple design; Extremely effective & very versatile. I love this product. Came with a pair. Added a new dimension to strength training at home for all the garage gorillas out there.

for home gyms you get a bar with a 1.2 thick grip, position that grip in the middle of the standard 1 inch par. place this pivot over the grip. then place the bar on a rack with a decent amount of weight on each end. Insert olympic bar into the pivot. you know have a homemade shoulder press machine.

well made, second piece is a bonus for me.

I wish one of the couplings was a little over 1" so it wouldn't be so loose on the cage safety bar but it still works great regardless.

Slides right over the pin/pipes on my Rogue R3. I use this along with the Titan Viking Press handle to add some shoulder exercise variations.Simple to setup, inexpensive, and it just works.