200 Sets Button Maker Supplies, 2.28 inch / 58mm Button Parts Buttons Supplies, Approx. 2.25 in Blank Badge Parts with Blank Paper for Buttons Maker Machine Pin Maker Press

My go to refills for pin materials. They're durable and easy to use when I make my pins. Some of the white pieces didn't come with the metal clamp things, but it's very few and doesn't bother me enough to write a bad review. Manufacturing errors happen. Not too pricey, either. I'd say it's worth the money. None of the pieces bend or break easily, and they fit to backpacks and other things easily, too.

Great deal, works as described. No issues using with my machine.

Excellent product. Did not have many lost punches with this set. Film was 100% and did not have any miss cut circles.

They work, and they make okay buttons. That said, there are three major issues with them. The metal for the top is slightly domed, which means when you layer the paper design and mylar on top, they are tilted slightly; it builds up static over time and so what starts to happen is the mylar lifts and sticks itself to the top of the button maker as I'm trying to press it, leading to misaligned buttons. I'm spending a lot of time trying to stick my fingers in to get it in place, which wasn't an issue with the parts that came with the button press. The other issue is that the mylar is slightly too thick, leading to at least one crinkle on the edge of every button where the plastic buckles.The BIGGEST issue is that it lists itself as "800 pieces" all big up there in the listing title. This is components to make 200 buttons, it should be listed as such, and listing it as 800 is intentionally deceptive. It counts the paper slips that come with it as 200 of the "pieces" which is frankly ridiculous.

Easy to assemble. Great quality!

The 1.25” parts are SO much better than the Beamnova parts I’ve been struggling with for years. Thank goodness! I wish the 1” ones were as good, but they are almost impossible to open.

I really wanted these to work. They seemed like a great price for all-metal parts. Ultimately, though, they’re all machined slightly wrong. It took me a while to figure out exactly the problem, but I’m happy to share specifics now that I have them.When my initial buttons failed on two different machines (one an actual Badge-A-Minit and one an off-brand) I started swapping parts to see if I could isolate the problem. I compared with parts that I knew would work. I used the front and Mylar from parts I knew worked and tried only the backs from this set: failure. I tried the backs and Mylar from parts that worked and tried only the fronts from this set: another failure. While the mylars from this set would sometimes work with backs and fronts that I also knew worked, the results weren’t great. This caused me to do some digging.The problem was that none of the parts were quite exactly what they needed to be. The mylars are actually double thickness of OEM B-A-M parts. The fronts are just barely (maybe a 1/32nd inch) too big, causing machines to crimp them in before they’re fully seated on the backs. And the sides of the backs are too straight, which means that when the fronts are crimped down onto them they can’t actually reach “behind” the edge and get a good grip to seal the button.Add to that the fact that the packing wasn’t great. I got enough fronts and backs, but only 200 mylars, not 500 like I ordered.The whole thing was a regrettable fiasco.

Excelente Producto, llegó en la fecha programada.