John Deere OEM Easy Change Conversion Kit (AM131611, MIU13767, AM125424, TY22029) - MIU13767A

Installed this Easy Change Conversion Kit on my John Deere S160. Perfect fit and the engine will get a complete oil change from now on. After I removed the "Easy Change" filter, I had to drill a couple holes in it to drain all of the oil before throwing it away.

An oil drain tube was in this order instead of the normal air filter

This went very well for me. Just finished installing. Some tips:- the bolt that holds the easy change filter mount on is 28mm. I used a pipe wrench to get this off. Went fine, wasn’t super tight. An adjustable wrench should work too.- I read a review wondering how to insert the new male to male threaded piece. There is actually a hex pattern within that part. I put a cap nut on the bolt that fit in there and was able tighten that in place real good.- Oil will get all over the frame. Not much on the filter side, but it was rough to clean up.- The kit came with an extender for the drain plug to make the oil drain beyond the frame, wasn’t even expecting this, but glad it was included.- The square drive drain plug fit a 7/16” crescent wrench. Hardly any room to work with but I managed with the wrench pointed towards the back.- When I got the plug about ready to remove with just my fingers, I took a strip of aluminum duct tape (it’s about 2” wide) and I taped it to the chassis and kind of shaped it like a U to make a gutter for the oil to spill over the frame into a pan. So glad I did that, much more oil came out that side.- The extended drain plug tube can be tightened on with a 24mm socket, which I recommend you get because it can also be used to remove the blades from the mower deck.- I did have the mower deck off for this, since I was sharpening the blades too, made it very easy to position a pan for catching the oil.All in all, pretty happy with the purchase, and look forward to cheap and less wasteful oil changes in the future.

This is all you need to do the conversion

So called 5 minutes Quick Filter with Oil all in 0NE = $40+ puts in 40% of new oil. It means 60% of old is refreshed with 40% new oil. This isn't good enough for me. That's why I made this conversion on my new E120. Yes I'll have to loosen 1 screw 5/16 hex on each side of plastic covers to swing them out of the way to drain and change the filter. Old oil I take in milk jug to our recycling center. What I did wit the original 5 min Quick change filter which contain almost 1 quart of old oil? It ended with my other house rubbish on a dump. . John Deere didn't think about disposal. of that! Nobody will bother to puncture 5 minute oil filter to drain oil.