OME UCA0004 Upper Control Arms for Toyota Prado 120 Series and 150 series by Old Man Emu…

I have put 2500 miles on them in two months and they work amazing. When installing on a gen 3 do not cut the metal just bend it a little it will fit.

First, my car is a 2014 FJ Cruiser. wasn't sure this was a fit because it didn't say in this listing, but it will fit FJ's and 5th Gen 4Runners.FYI, I did a 3 inch lift several years ago and keep the stock Toyota UCA (Upper Control Arm). Toyota UCA's did the job but the Caster angle was more upright than the stock with this lift. The FJ had steering wheel response issues, and would have a mind of it's own on freeways as sometimes it would pull to the right than the left depending on the flatness of road. I also had a popping sound when hard turning on backing up.So, I finally decided on these UCA's as I wanted the increased Caster angle, which it did. it did moved the upper pivot point about an inch back making it easier to obtain factory specs. Still no rub with 33's on it.All I can say is I wish I did this when I lifted it. Steering response is GREAT, and alignment specs are back to factory specs. only issue I have is that you have to take the grease fitting off to put on a cover...so I left the cover off. Still a 5 star review.if you have a FJ or 5th gen 4Runner with 3 inch lift, don't hesitate to buy this UPA, you not be disappointed.

OME high quality parts.

Excelente

Fit great, perfect Alignment. Very solid product

Installed in a 2021 Tacoma TRD Off-road. Installed about a month and a half ago with about 700 miles. So far no issues and none of the issues regarding greasing the ball joints that others have mentioned.

Easy install, looks like good quality...until you try to add grease. For some reason the ball joint would not accept any grease- grease would feed through the zirk fitting (I checked it) but would not feed down through the boot. After trying to pump grease in, the top of the ball joint blew out of its seat, and as you can see in the picture, is quite rounded... it is supposed to be flat. After an initial call to OME/ARB CS, I returned the UCA, as they said the units were backordered, and had no idea when I would get any replacements. ** later in the day, a CS rep emailed and said they could send me a new ball joint, but I would have to press it into the unit myself). Id rather get my money back and try something else.

Easy installation. Need grease in the ball joint