Cowles Custom - Premium Universal Body Molding for All Vehicles - Easy Install, Black Finish, 1" by 14 ft, UV Protected, Long Lasting Flexible PVC

Perfect fit. Looks good and very well made. Worth it.

Great product. When I pulled my fender off of my 2016 Indian Chief Darkhorse motorcycle to do a brake job, I bunged up the original chrome strip badly because I was not paying attention. Looked real bad.I looked at dealer prices for replacement and ... No way. I would go without and just keep my embarrassing dumb*** mistake exposed at that price.BUT THEN, I found this 3/4 inch chrome strip here on Amazon so, I gave it a shot.I pulled off the damaged strip, rolled the remaining adhesive off pushing with my thumb, cleaned with 91% isopropyl and proceeded to stick this stuff on.I started at front, removing back of tape as I proceeded. It did not wrinkle around curves.The 3M adhesive stuck instantly like well, glue!I cut the ends off with a sharp knife using edge of fender as a guide.I did not even remove fender. Whole job less than 15 minutes! DONE.I am very happy and I have enough left to probably do other side and rear too! Looks exactly like the OEM strip!I'll update with longevity after another 30,000 miles or a year, whichever comes first!Happy and going for a ride!

I wanted a different trim on my truck than what on it prior. After I had a new paint job I used the carbon fiber to separate the two colors and it is perfect. I have received so many compliments already. The carbon fiber looks great. Very happy with the choice.

I bought this body side molding for two purposes: (1) Give my car a sportier look, and (2) protect my doors from minor door dings. It seems to be doing both. Installation was easy and after a month or so the adhesive is holding up well. I gave it a four-star rating because it is a bit pricy and we have not experienced extreme cold or hot weather yet. If it holds up well after a year or two, it certainly deserves a five-star rating.

I purchased this "chrome" trim to replace some I installed years ago on my motorcycle and was losing its adhesion. My previous trim was similar but was a V shape in section, to wrap around the edges of my fenders. This trim is much better, is just a flat trim rather than the V shape. It was very easy to install. I clean up of the fenders with rubbing alcohol and doing the installation during warm weather also helped. Very flexible and followed the contours of my fenders beautifully. Very happy.

I used this on one of my custom cars and it worked very well. Its been on there for about 3 months, out in the sun etc and so far so good.

Easy to apply

The media could not be loaded. The chrome itself looks really good. It looks like a factory style chrome that the vehicle would’ve come with. My only complaint is that the adhesive itself can’t withstand temperatures here in South Texas apparently. Even after prepping the surface correctly, make sure everything was clean. Make sure it’s taped down since it was curved towards the end of the chrome run, It only held up on that curve for about a week and a half then again this is Texas it gets over 100° so maybe the temperature is a factor but now I have to figure out how I’m gonna re-tack those corners down the actual straight run is fine. Makes me wonder what the difference between this and the ones from Temu or AliExpress are, I went with this, since it was namebrand.