✨ Unleash Your Inner Designer with Every Pull! ✨
The Hardware Philosophy Creativity Brass Box and Drawer Handle Hardware Pulls are a set of two elegantly designed handles measuring 3.11" x 1.89" x 0.47". Each handle is crafted from high-quality brass, ensuring durability and a timeless aesthetic. The set includes 0.8" nails for easy installation, making it an ideal choice for enhancing cabinets, drawers, and other furniture pieces.
I**R
Exactly what I needed.
Matched perfectly. The older brass handles.
H**N
Beautiful handcrafted quality
Used to replace the handles on a family heirloom mcm piece. Looks beautiful!
R**S
Nice craftsman look but you will need moderate woodworking skills to install.
I liked the final look. I made and used two router jigs to install this product. I practiced on surplus wood before the installation. It also required some carving for fine fitting. The screw holes are too close to the box for your fingers and leave very little wood for the screws. Hopefully, it will hold for the life of the drawer.
J**V
Look OK, but poorly made
These look nice, but they are poorly made, the handles catch when you are trying to lift them and the backside isn't symmetrical. The screw holes are a bit wonky. If you are just looking for a nice "look" and functionality isn't a top priority, then they're OK. The bottom line, you get what you pay for.
R**S
Nice look, bad design
I really like the look of these pulls, however the flang dosen't leave enough room for the screws. Once you router out the hole to insert the handle there is very little wood left for screws to grab. The screws that came with pull didn't set in the face plate correctly as well. The heads where smaller then the recess on face plate.
S**T
BETTER THAN THE PICTURE. .
BETTER THAN THE PICTURE. HAS A MUCH NICER POLISH THAN PICTURED... THE PICTURE HAS SANDING/GRINDING MARKS IN IT AND I WAS HASTEN TO BUY THEM. BUT WHEN I RECEIVED THEM THERE WAS NONE OF THAT.. THEY WERE A NICE STAIN POLISH NOT BRIGHT BUT SATIN. VERY PLEASED...
D**N
Nice looking, a little finicky to install
I used these as lift-pulls on the insert/lid for an outdoor redwood table that has a tub suspended tub underneath (think potting soil, or built-in ice chest). They look good, but routing out the hole to take them was a little finicky. First, over the entire are, about 1/16 of an inch deep. Then about 1/2 an inch deep to accommodate the sunken pull/finger access - but being careful to leave enough wood so the screws have something to bite into! then, you need to rout or chisel for the pins that the handle swivels on. If you're installing more than 2, make some templates and test on scrap first!
K**R
Perfect for a tight fitting area
Used for a dining room cabinet where chairs back up closely to cabinet. Perfect!
S**L
Good strong built and just what I needed for my outdoor floor traps.
The media could not be loaded.
Trustpilot
1 month ago
3 weeks ago