DC HOUSE 1000N High Speed 14mm/s Black Actuator Motor 4 Inch 4" Stroke Linear Actuator DC12V with Mounting Brackets (Not Include Wiress Remote Controller)

Works great. Plenty of power for my use.

Excellent actuator. Easy to use. We made pop-up 3d animal targets using this and an arduino kit.

Good product,Needs controller switch that is sold separately to function.

I wanted to wait a while before reviewing this because I was concerned about longevity from such a relatively inexpensive linear motor. But "so far, so good" ... and I'll update this review if/when it fails at a later date. (Whoops; see update below.) I'm using it to open a fairly heavy wooden "man gate" in my backyard fence, and it has plenty of power to do so. I teamed it up with a remote fwd/reverse controller ( https://www.amazon.com/dp/B0CSN27T1D ), which worked out perfectly. I'm a little suspicious of its IP54 claim, but we've had tons of rain here and it's holding up well. I may add a simple rain cover for it soon, for additional protection from above. Update: At the 9 week mark, my fence gate had swollen with rain so that it wouldn't close all the way. But the motor was trying its darndest to close it. I found the gate problem some days later, and the motor had burned out. No fault of the motor, but beware that it WILL burn out if you keep power applied for a long period of time without it being able to move to its STOP open or close positions. Update 2: I ordered a replacement, and once it arrived I installed it onto my fence -- and found that its CLOSE position was about 1/8" shorter than the first one. The drilled hole in the rod is in the same position relative to its end. The issue seems to be that the STOP limit switch adjustment is a little different between units. It would be great if there was access to adjust those open and close limit switches, but there is not. So I had to move over my fence bracket that 1/8" to compensate.

Works great so far 👍🏼 made it for a rear mounted roof light bar for my Offroad truck. Will be drilling and tapping the shaft end to accommodate a 1/2” heim joint.

Works as it should, but very loud especially when under a load. I have 3 different brands of these. I would buy one of the other ones next time

So far so good. Replaced existing with new style and brand.(this one). slipped snug O-ring on and glued it for some water protection. I’ll likely grease other union spots to seal out water.

Would give it zero stars if that was possible! Total junk stop working after a month and a half don’t bother!

Excelente calidad y funcionamiento. Lo utilice para un mecanismo de alas.

This was a great addition for my tractor snowblower shoot. Worked well during the summer when I installed it and worked good during the first few winter storms we had. The only issue I had was that the further it got cold out, the worst it got because it would freeze and wouldn't move. I understand that I am using in a creative way, definitely should have bought something more heavy duty. But no complaints about buying it.

I fully expected these to be terribly over rated for power and they are. Good for maybe 1/4 of their max rating, supposed to be roughly 1/2 of the stall rating. However they work well and I bought assuming they would have far less "push" than advertised.

Used for a week now, unit works very well. Quiet and strong. Feels very sturdy, I'm sure it will last for years and many hundreds of thousands of cycles.

Installé sur la chute de souffleur sur mon tracteur. Pas le plus rapide mais travaille bien. Je le recommande !!!