Performance Tool W1046 11-Inch Long Reach 90-Degree Bent Long Nose Pliers

Must have lost my first pair and had to have replacement great for helping lining up bolts in tight places or hose clamps alone

Needed to replace my pcv valve on my truck in a VERY hard to reach spot. The pcv valve was 7.99 and so was this so i figured it would make my life easier and surely it did! I not only used it to pull off and reinstall the hose clamps but the hose as well. And now my truck is fixed! I couldnt have done it without this tool. Now im happy to have this for use in the future. Very handy useful tool!!! I figured at that price if all it did was fix my truck its already worth every penny obviously. Seems to be built very well. Im in the hvac field 20 years but I do my own mechanical and plumbing and house work as well. This tool will grab onto hose clamps real well so u can pull it of with much more ease than regular pliers or channelocks. Especially hard to reach spots. And its angled just right. Would have made my life a lot easier if i had these years ago. And I dont doubt ill end up finding many more uses than i expected out of it too!

Needed something similar to these pliers for a repair. The worked well.

My 98 Ford Expedition heater hoses are in the worst place and when you have to repair, replace them it's not almost impossible to get at them, but these plyers makes it a breeze, so glad I have them

Good deal

Just what I needed

Perfect tool to pull up staples after removing subfloor and sheet vinyl. However, in two rooms, the builder used tiny (barely 1/4" crown), long (1") staples that this guy's "needles" can't get under. I also bought a 45 degree plier and it gets under a few more, but for most of the staples I've had to use a little nut pick to raise them up first. Then these make short work of popping them out, even though they're deep. I tried a lot of tools, including several sizes of regular (straight) needlenose pliers, but only the nut pick gets most of them. Not the 5-in-1, not the grinder/ oscillating saw, not the floor scraper, etc etc-- none of them get under these tight, tiny, deep staples. (Note to floor installers: don't use those tiny-crowned staples, they're miserable to remove as the OSB just splinters and stays behind under them when you pull the underlayment out, so they're low and tight even after you remove the long splinters. And don't space them 1/2 inch apart all over the floor, that's excessive!) Anyway--once the staples are raised, these 90 degree pliers work best of everything else I've tried. The 45s are good, too, and with their skinnier "nose" they get under a few staples.) I may try grinding the tip finer so I don't have to keep using a hammer & nut pick. These 90s have a very thick tip for needlenose (thicker than the 45 degree one and thicker than both my straight ones), but I suppose that makes them stronger.

These are medium quality at best, fit and finish is nothing special. They are quite long and until I had them in my hand I didn't realize how unwieldy they would be. I doubt I will use them much. For the price I guess they are ok.

Excelente

Atende meu uso que é " pinçar" peças em locais com pouco espaço sem danificá-las

When a musky or pike swallows your lure, these are a good pair of pair of piers to reach for.

Adequate quality, but will serve for the occasional job where a long reach with 90 degree jaws are required. Would have got 5 stars if they had been properly deburred - some sharp edges on the closing faces of the jaws. No big issue, and easily sorted - but for the price, I should not have to do this

Excelente calidad cumple con mis espectativas,tiene buen alcance para esos espacios reducidos😃👌