Motorcycle Hand Grips Universal 1 inch Chrome Motorcycle Grips with Throttle Assist and Anti-Slip Rubber Design Fit for Harley Yamaha Kawasiki Suzuki Cruisers

For my 2008 Suzuki Boulevard M50. Was able to use throttle tube from original grips, so didn’t have to mess with the throttle cables. A bit of Gorilla clear grip glue and all is well. Only problem is they could still use the end weights. Will need to bore out the holes under the caps to fit them. Also, couldn’t care less about the tab thingy on the throttle; will probably end up removing.

fits on VRCSA with little fitting

Too large for 1" bars, had to wrap two layers of tape on the bar to get a good fit. The throttle side had to be reglued.

Left grip is to large for 1" bar. Did not even try the right/throttle side. Figured why waste the time to make cheap junk fit. Should have spent the money for better one.

Took origals off, using palat knife and WD40, did same to remove the throttle tube in OXMART. I'll agree that the glue used in OXMART wasn't very good and when cleaning up it dissolved in water.Used some gorilla glue and let it set .. Good to go... on the clutch end I had to file down the inner piece of the cap that has 4 screws It was keeping from sitting flush against the turn and horn panel.

During installation throttle hand grip slid off the throttle tube, used electrical black tape to correct condition.

these grips are 1-2mm too large in diameter, and 5-10 mm too long, to fit correctly on 1 inch handlebars. This is a safety concern when driving on the road. I sent mine back.

The grips look good but a bit fatter than the originals, I'll get used to them, I hope.

Le caoutchou est très confortable