Dremel Parts 2610031628 Miter Gauge and Knobs

A Dremel accessory par excellence, for MS20 model scroll saw.I ordered two! I was a little concerned about the loose envelope these were each mailed in,as opposed to a rigid box for this, but both arrived unscathed.I am a happy camper.Best as always,Loren

Excelente accesorio.

I recieved a miter that was bent so bad it would not work. Amazon was good and replaced it but the replacement was also bent at the same spot. I was able to straighten it to work.

It works great on my saw. I can adjust to any degree for the wood and comes with the locking tabs for the side of the saw.

Apparently the size of the miter slot differs as the Miter Gauge we ordered does not fit. There are no options given for different sizes for Model 805.

waste of money

I had to return the first Dremel MS20-01 Moto-Saw Variable Speed Compact Scroll Saw Kit ordered, the blade was set so it hit the foot and the edge of the table in the hole cut for the blade to operate, Dremel seemed reluctant about that.The second saw, the blade still is not centered but, close enoughsadly, I didn't use the miter tool for a year, other projects superseded that project.Tried to set it up yesterday, it won't slide in the channel that guides it, slides about three inches then hangs up on the left side, two inches on the right, pushed further, slides and bit then sticks solid, you could push the platform off the vices trying to move it, I considered just throwing it out and making a wood guide, then tried working it in the channel, copious 3 in 1 oil, wearing what every is stopping it.Definitely a problem with the channels in the table surface of the saw not being straight or more narrow in some spots because it slides and some points then sticks, and, at different points on the right or left channelAfter a a couple hours (in sessions to avoid hurting my wrists), I am able to slide the miter sufficiently in the section of the track I need to cut the arms for the snowflakes I wanted to make.If you buy one, test it immediatelysadly, you will probably not be able the return the Dremel scroll saw that is the reason the miter won't work.Dremel, used to be one of the most trusted products I used in three different work arenasit's a great little saw, just not as well made as it could be.I had a cheap scroll saw from sears I used for over 45 years, too loud but, deeper cut area and, it cut everything, the blades were SO much easier to replace and much sturdier with just as fine a cutsigh...

Cheaply built but works okay.