2PK 0.2MM CC2 Hardened Steel Ceramic Hotend for Centauri Carbon 2/CC2

Two weeks into my elegoo Centauri Carbon experience and I completely destroyed the hot end. Got this as a replacement since the original equipment is back ordered until who knows when. Put the the .4 mm hot end on, ran a calibration on the printer and it has been working great for the last several weeks. no print failures and print quality appears the same as the few limited prints that I was able to accomplish before the failure. The price was better than the original equipment as well.

I received the .2 and .4 pack the other day. I ordered them because the ones from Elegoo were taking WAY too long to get here (order day after I ordered the printer - received that on may 10th 25), and I was only working with the original .4 that came with the printer. I had a feeling that the original would fail before the ones from Elegoo arrived, and I'd be SOL. I bought the bullet, and ordered these. I haven't tried the .4 from this seller yet, but i am currently printing with the .2, and it seems to be running fine. I didn't do anything special when swapping the hot-end - just unbolted the original one, removed the wires (those small connectors are a nerve wracking to pull out), and reversed those steps to put the new one in. started the print and its working great so far. I don't have a set of calipers handy to check if any measurements are different, but just from looking at them; the only difference I can see is a different finish on the heatsink is different, and unbranded, along with the thermal-sock. The pictures are of the stock .4 on the left (heavily used) and the one on the right are from this seller. Aside from the price premium, I'm happy with them so far. If something changes, I'll update mt review.

Had my original hotend die so decided to order these while i waited for a warranty replacement. They heated well and printed ok, but the horrible stringing is where I had to draw the line. I was unable to solve it even with tuning. Not sure whats causing this, but both nozzles did the same. Just ended up returning to buy the Official nozzles for a couple bucks more and not have to worry about tuning.

I see absolutely no difference between these hot ends and the factory one installed on my Centauri Carbon (minus the branding). So far everything is working great - zero complaints.

Do I wanna pay this much for two nozzles? Nah. Not really. Do I like fast shipping more than Elegoo Customer Service? Well I purchased this item, yeah? But they print great. Check out the benchy using sunlu white abs

Have experienced no clogging with this hot end so far using PLA-CF. It's been more reliable than the Elegoo hot end

Been using this since I bought the printer and can't be happier. It's fairly easy to remove the hot end assembly (only a couple of screws). I appreciate having the .6mm nozzle and it's replaced the .4 for sheer speed and strength for non-aesthetic parts. Sure, prints still look good (.3mm layer height and only 1-2 wall perimeters) is fast and detailed enough for almost everything except small minis or really detailed text. Otherwise, this has been a welcome and highly valued addition to my Centauri Carbon 3d printer.

got Centauri Carbon and after a test print, swapped in this .6mm nozzle and it printed a 4 hour + nylon print perfectly. Only difficulty is plugging in the electrical molex type connectors but the factory assembly is just as difficult