FitBest 753-05251 GX22 GX31 Carburetor with Fuel Line Kit for WYL-19 WYL-19-1 WYL-229 WYL-229-1 Troy-Bilt TB590BC TB146EC Yard Man YM21SS YM26SS YM26BC YM26CS Gas String Trimmer

Came with everything I needed for my Ryobi 4 stroke modular yard tool. Carb, gasket, fuel lines, fuel filters. Dropped right in with little effort and fired right up. Thing was sitting in my garage for years and I almost just threw it away. I attached the chainsaw on a stick and pruned all the trees.

I have a Troy-Bilt TB525CS weed wacker, had to do some maintenance to get it running. I replaced spark plug, fuel lines an filter, new oil all to only fail. Spent well more than the cost of this carburetor in parts, tossed this bad boy into the weed wacker and it fired right up and runs like a champ.

I bought this for parts. I cannot comment on the actual carb function, as I just needed the throttle body actuator. It fits perfectly with a Cub Cadet 2025 string trimmer.The primer bulbs are cheap. I'm soaking one in gasoline to see how it holds up. *TO BE UPDATED*Fuel lines appear to be useless due to the length. They may be a perfect fit for the exact model noted by the manufacturer, but I'm skeptical.Overall, probably great for parts in many applications.

Easy to install fit perfect and engine ran good

This kit claims to fit a Troy-Bilt TB465SS, but there are some issues:The included spark plug is incompatible. (The TB465SS uses a much smaller plug with 10mm threads and tapered seat. See Champion RDZ19H. The included plug is perhaps 14mm thread.) The whole point in buying this particular kit is to get the spark plug. If that isn't useful, then there are cheaper alternatives.The gasket that goes between the carb and the engine intake is not shaped like the OEM gasket. There is a grooved air passage on the plastic intake body (used to feed air pressure to the fuel pump mechanism inside the carb) that the gasket is supposed to seal, and there should be a precisely positioned opening in the gasket for that intake passage. (See the two small holes at the bottom of the gasket shown in the product photo.) This gasket has two smaller holes instead of one, and they're close to where they need to be, but not precisely aligned. It might work OK...or the pump might get inadequate pressure. Will have to test it.

Installed in a Poulan P4018 and it runs great now. Make sure you get an adjustment tool so you can fine tune the cab after you install it.

Throttle cable has z endCarburetor has connector for bell endIf you pull that out by removing c clip, hole is too big and z end falls out of hole when you squeeze throttle switch

I got this to replace the one on my 4 cycle troybuilt tb575ss which has lasted me over 10 years. It worked after about 2 hours of toying with it, that is the only reason I am giving it 2 stars. The spark plug is the wrong size, the gas hoses/tubes are too short to use, so I had to purchase new ones, the unit requires you to tune it up after install, I’m still tweeting that and lastly the throttle cable tip had to be cut and modified to work. When is sais it is comparable that is it, the rest is on you to figure out. It is NOT a match to the old unit.