Ice Cube Tray for 30Oz-40Oz Tumbler, 3 Pcs Silicone Hollow Cylinder Ice Mold with Lid and Bin for Freezer, Ice Drink, Juice, Whiskey, Cocktail (Pink, 40 Oz)

Let me first say that I love the ice that this mold makes! I've only used it twice so far. The first time it was very difficult for me to get the ice cubes out of the mold. It took me probably 15 minutes and my hands are very sensitive to cold temperatures, so they were throbbing afterwards. That was with me trying to remove the smallest one first. I used it again this morning, ran more hot water over it first, started with the large one and used a towel to protect my hands from the cold. That really helped a lot. I think after using it a few more times I'll be used to it and it will be no big deal. If it becomes easier to use I will probably change this to five stars.

Overall, I like this product. It has a couple of downsides, but does the job it was meant to do. Pros: It works well. The ice "cubes" It makes are thick enough that the water in my Yeti tumbler stays cold for hours even when left closed up in a hot car. I can't say for sure that it would stay cold all day in that situation, as I haven't had occasion to leave it in the car all day, but my water certainly has stayed icy cold when left in the car for 3 to 4 hours in the direct sun. Though It took me a couple of uses to figure out the best way to remove the cylinders from the mold, it is quite easy now. 1 Peel down the outer part of the mold 2 Grab the inner "core" , top and bottom, and squeeze it towards its center, which peels it loose from the inner edge of the circle of ice. 3 Grab hold of the cylinder of ice and slide it right off. The first use, I did notice that my water had a slight flavor of the silicone, even though I had washed the mold before using. However, that disappeared very quickly, So it doesn't seem to be a problem. The hard plastic container that holds the mold while freezing is a very important item, and I'm very glad it was included. I have lots of other things in my freezer and can't always make room for the ice cube tray to sit directly on a shelf where it can be perfectly flat, so having that support is great. Cons: On the first use, there was a slight but noticeable flavor of silicone in my water, as stated above, but It dissipated by the second use, so it was only a temporary problem. While the hard plastic container is extremely helpful, the lid refuses to snap on. Even setting it on the counter, getting one end In place and pressed down, when I try to get the other end of the lid to snap into place, it simply won't. Even holding one end down tight and trying to press the other end into place doesn't work. The lid simply will not go on. It is possible that this is just a random defect with mine, but it is there nonetheless. And finally, although this is not a con but just something to be aware of, do not fill the molds all the way to the top. Water expands when it freezes, as we all know, and when I filled the molds to almost full, I couldn't fit the lid on my tumbler with the ice inside. The first time I used these, I had to run the top one under hot water and melt off a good quarter of an inch of its height. Now, I leave a little more than a quarter of an inch of headspace in each mold when I put water in, and that works just fine.

It fits my 40 OZ Stanley perfectly, great for summer days. Just a bit hard getting it out of the holders every time, so you need to be patient otherwise you will hurt yourself

works good

Me gustó ya que es muy resistente y de buena calidad. Recomendada