Angelguoguo Blue ABS Car Engine Start Stop Switch Button Cover Trim Replacement for Alfa Romeo Giulia Stelvio 2017 2018 2019 2020

The media could not be loaded.  Used on Alfa Romeo Giulia (2020) Ti Sport (should work in all Giulia’s! This is not an 3M stick-on cover (yay!!) and clips in to factory push assembly nub. It even allows LED light to come through writing to show at night and looks very very stock!Perfect fit & size!Highly recommend this vendor/product if you want the Quadrifoglio red button look for your Alfa.Simple 5 Min. install…To remove the button you have to remove the whole stock factory button assembly first:Use patience and using a ballpoint pen top/cap (see video) to push small piece of dental floss around the edge of button to form a loop & catch the button assembly snaps. Tip: Tie a knot to hold each of the 4 floss loop pulls tight around the catches to keep the floss from slipping off when you go to tighten strings just before you pull assembly out.So…After all 4 loop/floss pulls are ready to go - just give it a quick even pull (all 4 strings at once)… Pop; assembly and button will come right out.Then carefully use a needle to remove black flat button’s 4 clips, and swap button with red one purchased here on Amazon.Once assembled again- push the whole assembly back into the steering wheel hole… You’re all done!

Look for the install video on YouTube with the cap to a bic pen and dental floss. It wasn’t as quick or as simple as it looked online but not that bad either. Getting the floss behind each clip with the pen cap does not scratch the ring around the button. When you pull the cap and the part underneath come out together. You then use the small screwdriver to remove the old cap and install the new cap - then you insert the combined part back into the slot. It’s slotted to make it an easy insert. The descriptions on here are a joke, there are no screws, no wifi access and whatever else is selected…..

This was a great quality button. Fits perfectly. Great deal.

It fits OK but with a little bit of trouble. The clip in portions on side are very thin and 2 broke while trying to get them on. Luckily they did not break completely and was still able to get it on over the factory part. Removing the original was a bit challenging and to do it I used 4 pieces of fishing wire and slowly pulled the start button out by pulling forward while jingling it from side to side and unclipped the oem black cover to add the red. Being very gently while mounting the frigile reb button cover is important. Looks good but the quality could be a lot better. I'm sure if I ever have to take it out it will break completely

I got other eBay buttons and they were so cheap made, this one met my expectations.

So please keep in mind this is a button replacement and not a cover!! You have to carefully pop out your old engine start button and pop this in! Super easy once I figured out how to get the old one off.. I would put some tape around the silver part so you don’t scratch it when popping the old one out

Pero le falta instructivo o algún video de cómoColocarlo 🙁

Nice quality. The fit is perfect.