Goupchn LCR Meter Test Leads Terminal Kelvin Clips Cable Wires to 4mm Safety Banana Plugs 1.2m/3.94ft for DMM

I got these to use with my Siglent SDM4065A bench DMM for measuring resistances under 100 ohms. I tested the leads on high-accuracy Dale low-resistance resistors, and the readings were spot on. The serrated jaws are perfectly parallel and grip very small wires securely without slipping.

Good build quality, works perfectly, showed no tendency to fall apart. I used my (dumpster dived) Fluke bench meter to measure some suspect automotive fuses. The 5A fuses (ATM-LP in this case) should be 17 milliohms and they were. Fake Chinese fuses come out much lower, like maybe 1-2 milliohms. I can't measure that low with real accuracy.

Good value for the money and they work just fine.

Well-built set of Kelvin clips. Gold coated alligator clips are well aligned and grippy yet small enough and unintrusive, banana plugs have overmolded strain reliefs, there are properly designed retention clips for the pair of cables along the way, not just heatshrink, and cables arrive properly on each side of the clip, not combined like in cheaper sets. All that for the same price as the lesser built ones. Now permanently attached to my HP 4262A LCR meter.

I bought these to use with a home-made milliohm-meter. The worked out perfectly. The leads are flexible, plenty long and the tension of the alligator clips is just right. They hold tight but are easy to open.

Excellent 4-wire, or Kelvin. test lead set, especially for the price. The leads are flexible. The Kelvin clips work well, they are made well, but relatively light duty. The banana plugs fit and hold well. The following images show 4-wire measurements using a Fluke 8520 meter with the clips shorted, measuring a 10 ohm standard resistor, and the clips on the 10 ohm resistor. Highly recommended. I just ordered a second set.

These seem to perform identically to the "real" (P...a) ones, for about 1/20th the price. Using these for DC resistance sensing, and copper is copper. It's a low-tech connection. They're not built as well and I'm certain they won't hold up as well, but for the price I could replace them 15 times as often as the name brand, and I'd still be way ahead.

Love them. I bought a second pair now.

低抵抗計メーカ純正の4線プローブが あまりにも高価なので、本品で代用。実測値は純正と変わりませんでした。心線も純正と同じぐらいの太さなで作りもしっかりしていました。

Very good quality for the price. May not be professional grade but works perfect for the occasional usage like we do. Works with our Siglent SDM3055 Digital Multimeter. Plug these in, short them together, REL on to cancel the ohms of these probes and you are ready to test low ohms. At these prices you can buy a few of these if you use them often and still come out ahead compared to more expensive units. I would purchase again. Very flexible cabling. Five stars for price to performance ratio. Pictures show meter and measurement of 0.1ohm rated resistor.

Works great with my Fluke 8840a. This is a must to have with a compatible DMM.

Very good quality and very soft to the touch.