5PCS TEC1-12706 Peltier Module,Aideepen 12V 6A 60W Heatsink Thermoelectric Cooler Cooling Peltier Plate Module Peltier Cooler 40x40MM Compatible with Peltier Fan/Cold Plate

They worked as expected! Bought a 360W power supply and made this cooler with two huge heat sinks. My buddy and I then but some piping around the hot (exhaust) and cool side. We blew air over both sides and directed the cool air into my gaming laptop to keep it cool while gaming and it worked really well! We used cheap thermal paste to get good contact from the pads to the heatsinks. Also, data sheets for these things are all over google. I found a few english ones no problem. One more thing, they do not draw quite the amount of current they say they will, but that is a small detail. If you toss a bit more voltage over them, they will draw more power obviously.

Surprisingly, all the pieces arrived in good condition. Considering the poor packaging and other purchases from this vendor that arrived broken and non-functional, this was a surprise. Performance is what you'd expect from a Chinese 12706. Performance is a little below US made but more expensive TECs, but they are consistent between units and in testing I was able to get a medium sized cooler down to 26 degrees F (ambient 67 deg. F) using a liquid-cooled water block hot side and a super efficient 10" x 4.5" x 1.5" 22 fin heat-sink. Anything less would not pump as much heat and would not cool the chamber below about 35 deg. F. These units draw 1/4 the power of the Aideepen TEC1-12715, and are much more efficient. Assuming the next batch is as good, I would definitely buy them again.

Funciona muy bien, solo tengan encuenta que si no refrigeran la oarte que se calienta entonces no va a enfriar casi nada y al contrario se va a calentar muy rápido

Doesn’t hit 60w rated output. When given 12volts it only will draw about 3.5Amp otherwise they are functional

Hot side gets hot Cold side does get below freezing (If you can heatsink the hot side With large sink and fan , and also sink The cool side) You get ice on cool sink in still air, No ice on sink in moving air. Good if you can rig up some creative Something or have cooler fitted for them Limited practical application though Who knows Cheers

Did not work on my brew Jacket cooling and heating stick.

Bought these to try to cool an outdoor camera setup, and they work as advertised. My first impression came when I was holding it in my fingers, expecting some slight temperature change. Hooked it up to a 12v battery and pretty much immediately had to drop it. It was only then I was able to realize that although my index finger almost got burned, my thumb was ice cold. I can understand why people say they destroy themselves when left on without a way to dissipate the heat, but come on - pumping heat from one side to the other is what they're supposed to do! I bought a little 40mm copper heat sink with a built in 12v fan, and these things will run all day long if you can get rid of the cold on the other side. Surprisingly great technology, and great product

I have not yet tried them..waiting for connector order. They are a. bit smaller than i expected.. ans lead wires are a bit short

The supplied items matched the advertised items and all worked.

Works perfectly! Super fast delivery. Very pleased

وصلني ٤ قطع شغالين ووحده خربانه

Both of these weren't working even after changing the motor. Installed these and they are back to thier old glory.

So I did some research and I found out that this part would replace the one in my wood stove fan but I couldn't find what the FX stood for on the oem part. Now i know, it must refer to the wire having a higher melting point. So i couldn't find an fx version part so i covered the wire with a teflon sleeve which will work and kept them from melting. oem part on the right in the picture