Motion Pro 01-0094 Throttle Sleeve

Great quality fits 2005 kx250f.

I bought this throttle sleeve because the OEM one on my 1982 Suzuki GS650G had been damaged from a fall by a previous owner. Even though the Amazon matching system said it would not fit my cycle I found that it went on perfectly. Absolutely zero issues with fit and it seems to function well. Like the description says, it is likely this part will fit any early 1980s Japanese motorcycle. I was pretty concerned since the OEM parts are impossible to find but this motion pro piece fit perfectly and saved my bacon! I don’t generally write reviews but for anyone restoring an early 80s Suzuki this part will most definitely work. And it’s inexpensive which makes it a great deal.

Nice throttle tube . Should fit all Yamahas or 7/8 handle bars. This fit my 2008 Yamaha FZ6 perfect. You do have to saw off the end of the tube if you have any attachments on the end of your handlebars you want to use

Bought this because some reviews said it worked for SV650, I just want to document here that it in fact did work on my 2003. Was a mostly easy install, despite one hiccup: the "stops" of the tube that limit it's rotation within the cable housing (seen as extra material on either side of the two cable holes) are not quite tall enough, and end up binding inside housing. I filed it down a bit, though not sure if that was needed, bc I think the solution was to compensate by using the cable freeplay adjusters such that the stops don't touch anything inside the housing. Got it to work in the end, and throttle throw is much shorter as other reviews here state.

Cheaper than cycle gear

In short, this does work and has the same cam as the KLX250S stock throttle tube. You just need to remove the end cap of this tube to fit it to the stock handlebar and control location. See the pictures. I purchased this to add heated grips on my 2009 KLX250S because it is relatively cheap and I did not want to clean and grind the lip off my stock throttle tube. The cable cam is the same as the stock Kawasaki throttle tube, and tube length is perfect for the stock handlebars and control position. In order to get this tube to work with the stock bars and control location, you must remove the endcap that comes on the tube. The easiest way I found to remove the end cap was to place the tube on the handlebar and slam it down the handlebar so the the end of the bar hits the cap and pops it off. From there, I cleaned the handle bar and sprayed it with some silicone lubricant, whipping off the excess, and positioned the tube and controls to finish the installation. On the stock handlebars, the throttle tube is about 1-2 mm short and the bar does stick out some, so make sure not to fully seat your closed end grips against the end to avoid any issues with the throttle sticking or moving sluggishly. I used open ended Oxford heated grips for my install and glued a home made cap to the ends of them. Use your own judgement when installing your grips, and make sure everything is free moving. I recommend dry fitting and marking fitment locations with a pencil.

This fits perfectly on the Protaper adventure bar I got for my klr650.

Tight fit on painted bar requiring sanding, smooth operation

Awesome modification for 2023 mt07. You will need every bit of throttle cable slacked off but it fits and the bike is a lot more responsive. Front tyres will last longer because they spend less time on the road.

Excelente producto aunque el tiempo de entrega se demoró demasiado

Used on my Yamaha MT07 Tracer , shortens the amount of turn and smooths out the throttle action in my opinion. Well worth the 5 mins to fit.

Perfect fit for my TW200. Better quality than OEM.

Quality a bit soft