Proxxon28732 3-9/64-Inch 80mm Carbide Tipped Saw Blade 36-Teeth

This arrived quickly and was well packaged. Item exactly as described. Will buy from again.

Nice for small table saws for cutting difficult materials.

very good. i am satisfied very much. thanks

The only real issue is that one of the teeth was missing. They're clearly not glued on very well for that to happen but it still cuts pen blanks very well.

Good basic blade for getting stock to rough dimensions. Prominent kerf marks and wide kerf, as typical for carbide blades, may be drawback. Probably not the blade for finish cuts.

The Proxxon saw and blades are pricey but a nice alternative to trying to cut small parts on a big table or mitre saw. (saves fingers!)

Good!

Cuts nicely. Does the job.

Excellent quality blade. I'm using this on Beech wood dowel (12mm - 25mm) with my Proxxon KGS80 chop saw. Works a treat, much better than the 24tpi blade which is more suitable for metal stock and general use. Little to no splintering with masking tape wrapped around stock, and only a bit of 'flashing' left over at the bottom of the cut, this is usual with chop saws though and is easy enough to sand off. Definitely worth it, makes my life a lot easier.

Brilliant product works well

Do not but this blade for the bosch 12v circular saw it does not fit properly and wobbles about like mad very UNSAFE

Nice, sharp blade. Deals with cheap plywood well, without too much splintering.

Dose the job