Incubator Warehouse Fan for Little Giant 9300 Incubator - Egg Incubator Fan with Quiet Operation - Pre Wired Durable Incubator Circulation Fan - High Performance Heating Fan with Installation Guide

Got this to add circulation to my still air little giant incubator. It came in super quick. Followed the super easy directions and it made the control panel spaz out. Called customer service and got a replacement in 3 days. New one works flawlessly! Here is to upping my already good hatch rate!

Easy install except the glue was junk and probably unnecessary to use. Just don’t Neanderthal the heater and you’ll be fine putting it back together. I’m happy with it.

Instructions were easy to follow, kit came with everything needed. My only complaint is the glue was dried up in the tube. I didn't want to send it back and have to wait for a replacement so I bought the glue I needed to install the fan locally. Other than the glue, everything works great.

I was Leary when I bought the fan that I could install it in my incubator, but the instructions were simple to follow and in just a few minutes I had a fan in my incubator and had the best hatching ever of my baby chicks.

it works and its quiet, it also came with simple instructions, I now have increased the hatching rate for my incubator YAY!!

Buy this one! This is the one that works and fits, and does what it is supposed to do with no issues! I bought a knock off and it failed miserably, and with deadly results.Because I bought the still air version - partly due to the low cost and my need at the time - I did bought an egg turner, but the heat and humidity was so uneven that I had a very high mortality, including chicks stuck in their membranes.Buy THIS unit - it is also quiet, and the perfect aftermarket product to turn your Little Giant into the incubator that I should have bought in the first place.

My incubator was marked as late Jan 2020 but had posts on the cover not as shown in the instructions. However they were fairly easy to cut off and install the fan as indicated. One you install the fan, forget any temperature settings you had before (I had to be 1 degree warmer than what I wanted eggs to be and had the humidity figured out) the fan will (as expected) change the dynamic inside the incubator. So far so good but its only been a few hours ...

Read all the directions and then throw them in the trash. Then see what the end goal is and do it. Don't follow the directions or you do 30 more steps than needed. You risk damaging stuff you don't need to touch.