Offset Oxygen Sensor Socket, 3/8-Inch Drive, 7/8-Inch (22mm), Wire Gate Accesses Sensor from Side, Preventing Damage to Wires, Universal for Most Cars

Muy bueno facilita quitar y poner los sensores de oxígeno.

Does what this is supposed to do, remove an oxygen sensor. Had a challenging but not difficult spot on my Toyota Highlander to get some leverage on a 22 year old bank 1 sensor 1 position. It's accessible, visible but not much room to turn the socket with anything that can provide any sort of leverage without the handle hitting the subframe or steering rack. An 1/4 turn at a time until the sensor was about 90% spun out due to rust. Using my usual deep oxygen sensor socket would put lateral pressure on the sensor when twisting it and I didn't want to crack the sensor. With this short socket, it puts pressure just on the sensor hex and will take a lot if 1/4 turns because of the crows foot design. Price is totally affordable and seems sturdy enough. Recommended as a back up in any one's toolbox.

I bought this and lost it shortly after. It was my own fault I looked like it would have worked. I'm looking forward to the day I find it and can put it to good use. Thanks for sending it.

Invaluable or priceless. Or something like that, If you need to do O² sensors. But I don't envy you a bit if you have to do them. Good luck. This is a pretty great tool though, I recommend it over the straight socket, as you can use it for both the sensor that is pre cat and post cat. Multiple sensors...

Buen material