2PCS 70 inch Running Board Lights, 864 LED Strobe Lights

Lights are nice and bright with many different patterns. Quality looks really good, Wiring was a breeze since the lighter plug unplugs from the lights. Mounting was super easy took about 5 minutes per side and that includes cleaning the running board. The adhesive seems to hold really well. Value for money for me is worth every penny. Definitely recommend.

Great item

Easy install and very bright. Day and night they look amazing. And the length was perfect for my truck. Installing both sides took me only one hour and a half. 10/10 would recommend. 👍🏻

I purchased these hoping they were going to add some lighting to the side of my fleet vehicles and decided to give these a try. Being that our fleet vehicles make frequent stops along roadways and highway for inspections. Right out of the box seemed to be decent. I throughly cleaned the area where directions instruct for installation. Installed the light strips with two supplied brackets on both strips and screws on the end of the strips. The lights were installed in a climate controlled shop. The next morning pulled out of the shop and took a 15 mile drive at approximately 45 mph and heard a loud noise and saw the cord pull then snap. Apparently, the adhesive failed and flew underneath the back tire of the truck. The adhesive was still on the side of the truck but the light strip on the passenger side was gone with the wind. And the drivers side ways barley still on. When illuminated they were decently bright. I guess I will be searching for a similar product for the rest of my fleet vehicles. Apparently, I can’t return them since the one of the strips is who knows where. Did not even last 12 hours on the vehicle. I really wished they worked. I would hope they make it right.

Was easy to mount on plastic but metal the screws broke.

These are very good and super bright. The only issue I had, the 3m tape does not stick well.

I had previously asked whether these can be cut to size. The answer, without exception, was no. I have added the red/white to my Sequoia luggage rack on the left and right side - the 70" was perfect in length. I added a third to my existing 52" curved white LED light bar. But since the 70" was too long, I had to cut the strip. Since the end with the cables seems to be fused in plastic, I opted to remove the opposite end. I cut the plastic tube without damaging the LED strip. I then pulled the strip out as far as it would go (stretching it), and cut it. This let the strip slide back into the tubing by about 1/2". I then sealed the open tubing with clear caulking. It is important not to allow the tubing/strip to experience any temperature changes while the caulk dries - else it will suck it in (if it gets cooler) or push it out (if it gets hotter). The results are fantastically bright LEDs above the roofline that can be seen from hundreds of yards away. In fact, these were brighter than the mounted emergency light bars I had previously installed - so I removed them. The beauty is that the strips all but vanish against the black luggage rack and light bar - until they're turned on. And with the larger light bars gone, I don't look quite so dorky/obvious. I used standard rubbing alcohol with paper towels to prep the surfaces. The 3M VHB tape on the back of the strips are really stuck on there. The luggage rack is relatively smooth, so I expect them to hold without any further adhesive measures (i.e. zip ties or screws).

Great lights very bright night and day easy installation good adhesion washed my truck with pressure washer and had it in rain /mud doesn’t effect lights at all

Very bright durable. Really gets your attention!!! Standing up to the cold Canadian winter and working great so far!!

When the temperature goes down for low -20 only half of them work. As the days warm up, then they start to work. Some days when they’re cold the flash patterns don’t work.