VEVOR Metal Cutter Drill Attachment, Metal Shears Attachment with 360 Degree Pivoting Head, for Cutting Max. 21 GA Stainless Steel, 18 GA Galvanized Steel, and 14 GA Aluminum Metal Sheets

works very good on cutting metal roofing for house. Took a minute to figure out how to work it properly but once I did it was off to the races.

This did not work at all with the makita cordless drills I use. The collar is not wide enough to fit over and does not cut on an angle the normal 5 rib metal decking.

Cut through metal roofing with no problem. Not a fast process but smooth cut.

It works great the only thing I would change is the stabilizer bar thing doesn't really hold like it should

Una herramienta útil , funcional y de fácil manejo ,

A mí no me funcionó tal vez estoy asiendo algo mal, lo que probado y no corto nada

would be good for FLAT 29 gauge sheet metal.

This does cut classic rib metal. The jaws do not open far enough. The cinch does not hold and comes off of drill.

Terrible attachment. Wasn't stable. Didnt cut very well. I couldn't manage with my arthritic hands.

1. cutting: The opening angle of the two scissor blades is too large, so the sheet metal tends to be pushed away. I tested with soft zinc sheeting (less than 1 mm thick), which is really easy to cut by hand: you had to push really hard to make any cutting progress. Then, when you need to apply too much force, the cut will get jagged. 2. The frame that should fix the device on the drill is too wobbly, so it tends to fall off or the clip would open all by itself. Best left on the shelf.

Loved it bought another one it was junk (only for flat tin) i ‘tinned a whole building and this is the cutter i used. Fast an efficient worked best on my Milwaukee impact ( not as bulky as a drill)

I haven't found any metal yet that this will cut. I am trying different adjustment settings for no success as yet. I need it to cut Colorbond fence panels. Any suggestions would be welcome.

Moyen