The Uniwheel® Shower Door Runners Pair

After searching for years to get replacement rollers for my shower enclosure these did the job in minutes. They are certainly a bit pricey but well worth the money compared to buying other rollers that turn out not to fit as every shower enclosure seems to use different sized rollers. Robust and easily adjusted

I used the uni wheels to hang my shower door which I didn’t know the make of, and the existing fittings had cracked. They are not very similar looking to the original ones but do the job brilliantly. The shower door moves so smoothly now and it has saved me a fortune as I don’t have to buy a curved glass shower door now!!

Excellent product worked well for my Manhatten quadrant 800 x 800 shower doors, far better than the original wheels, greater adjustment scope, reasonable price not much more than the cost of an original set. Recommended buy for the price.

Very disappointed in these. Watched the video, answered the said "questions" before purchasing , all okay so thought I had covered everything off. These are 100% not universal, beware! Firstly the rubber washer that feeds through the hole in the glass was too big (no spare smaller sizes). Thought, okay I will shave/cut around the circumference to make it fit. Washer then fitted through the glass. Problem 2, to get the bottom plate to sit flush under the glass you cannot move the rollers into a position where you need to as the slack on the adjustment was the opposite way to what I needed. If you allowed the glass to not sit on the bottom plate the rollers were okay, but then pointless as there is no support. The next issue was that they are too bulky so as you pull the door along it hits the the other piece of glass. Absolute waste of time and money.

Super quality stainless steel body, sturdy wheels. A bit fiddly to fit the first runner but once you get the hang of it it’s easy enough to fit. Finished result is really excellent. Just amazing quality. Makes the other runners in the shower look and feel insubstantial. Would highly recommend despite the relatively higher price.

This really is a good concept.However in my case the length from shower door to track made it too wide so water would leak.Wish i had taken pics of it, otherwise easy to assemble and use.

I have a shower cabin with two, curved sliding doors. The fact the item has two wheels didn't matter for the curvature, as I first expected. What did though is the fact that the door stops in my shower rail wouldn't allow the doors to shut tight as it's been designed for a single wheel.That said, I previously purchased some cheap generic rollers that also didn't fit. I was able to retrofit the single wheel from them onto the uniwheel body.The vertical screws were the same diameter. All that was needed is to unscrew forcefully the cheap roller. Then, on uniwheel, carefully remove the clip at the end of the long screw, don't damage it as it will be needed later. Replace the middle, threaded, moving part. Put the clip back on. If it became loose then you can squeeze the sides to tighten prior to pushing into the screw. Some thin flat headed screwdriver, thin pliers and Phillips screwdriver were needed.Pictures attached. Hopefully it will help someone avoid fitting a new shower cabin just because the rollers failed.

Worked perfectly. Very easy to fit and has made my shower door glide beautifully once more.Saved a fortune in money and time, as I didn't have to find an original part (which was possibly going to be impossible) and whilst not the cheapest thing in the world certainly don't think it was overpriced.The product is also well made and has the feel it won't break as easily as the original manufacturers one did!