Modern 4 inch Centerset Bathroom Sink Faucet Brushed Gold, Two-Handle Center Set Lavatory Vanity Sink Faucet 3 Holes with Metal Lift Pop Up Drain Assembly

I purchased 2 of these for my spare bathrooms, replacing a single lever low spigot faucet. First, the construction seems solid, not plastic, feels like a quality faucet. Handles are firm and solid, chrome seems to be good. Hook up is easy. You probably should replace your water lines. I purchased 16" braided lines with 3/8" on one end, 1/2" on the other. 3/8" to connect to the house water supply and 1/2" to connect to the faucet. Tighten firmly but don't put everything you've got into it. Also the metal drain is nice, I didn't use any sealant as it has rubber seals for both top and bottom of the sink. Easy enough to put in, tighten the nut under the sink pretty tight and you should be good to go. put together the drain lever pieces and tighten the ball in the drain assemble snugly and you are done.The one thing I don't really care for is the drain rod but to make it decent I adjusted the drain plunger to open just enough to made it drain well but not so much where the rod lifts a lot. A little adjusting there and you will have it like you want and be done. I finished both sinks, turned on the water and let them both run for a while, no leaks on the incoming side or the drain. Took maybe 30 minutes per sink which includes getting out from under the sink to look at alignment and so on. I'm a good DIY'er but not a plumber by trade. If you are handy around the house you can do this. My end opinion of this faucet is it's of good quality, looks nice and is easy to install. The spigot is higher than some but it gives you plenty of room for washing hands, filling a glass, etc. There are some a little lower and I was a bit worried about it being too high but after completing the install I think it's fine and looks good. It's a good value for your hard earned dollar. Only been a few days since installation, will update my review if anything changes.

I looked at many many faucets before choosing this one! It looks amazing,! The attention to detail in the finish is really wonderful. Works hreSt and very elegant presentation .

It is well made and good looking faucet. It was easy to install without having to twist and crawl under the vanity and more so that I used the existing drain assembly. Although I used the existing drain assembly, but it doesn't look as good as the faucet. I would have preferred to replace the whole thing with the new had the faucet come with one. If can ignore this shortcoming, I would highly recommend this faucet.

This faucet is well-built and high quality. In comparison this faucet to other faucets from popular companies in this price range such as Peerless and Glacier Bay, this faucet is probably the best for the price. First of all, it comes with ceramic valve cartridge, so the handle can be turn smoothly even with one finger. In the long run it is expected to last longer without leaking. Secondly, the body is fully metal and made of brass with top-notch chrome coating. The package also includes 2 hot and cold watelines, but no drain included. This faucet has a hole in the back to accommodate the pulling rod for those old technology drains. Now if you plan to buy a pullin-rod-pop-up drain to install together with this faucet, that would be perfect. However, I don't like to use a pullin-rod-pop-up drain because it is harder to wipe in the back of the faucet. I installed this faucet with a new-technology-push 'n pop-up drain, and that was why it was not perfect. I already confirmed with the seller and a reply that this faucet does not have a cover for the hole in the back (in case it is not needed) like the Peerless faucet. I was planning to return the faucet, but after discussing with the seller, I decided to keep it. To cover that hole, I went to Homedepot and bought clear caulk for a few dollars and covered the hole. Not perfect, but I am satisfied with this faucet. I might consider to buy a few more to replace faucets in my house and office. If this faucet was designed with a chrome coated plastic cover to snap into the hole in the back in case it is not needed, it would be a perfect faucet.Many of buyers posted negative reviews about the leak that is because they don't install the faucet properly. Here is how: Always use teflon tape for hot and cold waterline hoses and use a long beak plier to tighten them before installing. In my opinion, the manufacturer should have done this step before shipping out to make it easy for some buyers without plumbing experience. This will prevent a lot returns and negative reviews.

I purchased a pair of these to give a spare bathroom a quick refresh, replacing some old Delta "crystal ball" faucets. Comparing them to my old faucets, the build quality seems very comparable to the old Delta faucets. Construction is all metal as stated. The handle, while note quite as tight as I was hoping for, still feels very solid. Waterflow is fine, temperature control is fine. The attached hoses were plenty long and flexible aiding in a very simple install. All in all, very good faucet priced much lower than you'd think.My only real gripe is the sticker with a QR code placed on the underside of the faucet. As you see in the photo, adhesive was left behind!

The faucet was a replacement for one that wore out. It was easy to install since the water supply lines were already attached. Just the 2 faucet lock nut to mount it and the 2 threaded female couplings that screwed on to the male threaded shut off valves. I don't believe there were state sales tax charges.I like this one better than the earlier Delta faucet it replaced. It is low priced enough buy another one as opposed to buying overpriced valve insert cartridges that Delta offers. The faucet is equal to or better than any comparably price faucet. I plan to buy a couple of these for the other bathrooms in order to have them around just in case.The only real draw back is the name which is hard to remember.

I have been using it for 7 years with no issues at all. It never gave me a problem and still looks new.

I like the look and feel of this bathroom faucet. Installation was straightforward, everything fit and worked properly. Even the matching drain was included.

I purchased the polished Chrome faucet for my upstairs bathroom, installed it, and it works brilliantly well. The build quality, and finish are really good. Two weeks later, I purchased a second same model of faucet in the brushed stainless steel finish for my main floor bathroom, installed it, and once again, I am very happy with how well it looks, and functions. Instead of using that included drain assembly that, came with both faucets, I purchased the more expensive drain assembly with the brass catch basket that seats inside the drain assembly with the push directly on drain plug push down, and up because, I like the idea of the basket catcher. Great if a small item falls into the sink, and is not able to get lost or, trapped in the drain. As shown in the the two photos I took of the brushed stainless steel finish faucet, and the drain, they match together very well with the brushed stainless steel finish. I really love the high stack of the faucet spout, and that it is more in the centre of the sink thus, having ample space for hand washing. My old faucet was very low, and the spout was more closer to the back of the sink opening which did not leave much space for hand washing, and low if I wanted to fill up my bicycle riding water bottles. With this faucet being higher, the spout is much easier to place a water bottle under it for filling up, and more easier for hand washing. If anyone is wondering about the quality of this faucet, I give it a full five out of, five. I highly recommend anyone to purchase this faucet. Do not let some of the poor reviews turn you away from purchasing this faucet set. As far as the supplied drain assembly that are include in with the faucet, I am sure that they will work properly since, they are pretty standard. Since I used a totally different drain assembly, the original ones, I just placed aside with my spare plumbing parts.

Great vintage farmhouse look for an even better price. Took about half hour to install. Highly recommend.

Heavy Solid brass, with a flawless polished chrome finish. It also comes with a quality popup drain assembly.I had previously paid over $30 alone for a similar drain assembly on a different sink.It's an easy install and looks great. It's style also matches up well with the MOEN Brantford tub/shower trim.The handles operate smoothly, has nice flow and drip-less when shut off.What a great buy this is, very pleased.

Very solid. Easy to install. It's not a matte black like I was hoping. It does say oil rubbed bronze but the pictures show as black. Still looks good though.