Dual Water Feed Boat Motor Flusher Rectangular Cup Muffs with Hose Fittings Flush Kit – Marine Outboard Engine Flushing

Works well. Used it for the first time last weekend. Fits snug and pushed the water through my v6 mercury 150 as you would want need and expect.

This unit is outstanding. I have an old runabout at my Minnesota lake place that I’ve always performed my own service on. The boat still looks and runs like new. Unfortunately I somehow misplaced my old motor flusher while cleaning out a shed over the winter, so was in need of a new one. You never really know what the quality is when you buy online until you get your hands on it. This product exceeded my expectations in every way. Cost a few bucks more than some of the cheapies but I guarantee it’s the last one you’ll buy (unless you lose it!) Sturdy, well made from obviously good quality materials, and worked flawlessly. A very nice unit👌

good quality, except it does leak on my new outboard out the front of the device inlet seals, they do not seal under moderate pressure, still it seems to pass enough water to get it flushed, but not 100% sure due to the leakage, doubt not good when you are flushing you're new, expensive out board---

This thing is pretty good quality. I also like the fact that water comes out of both sides. Although it seems to be really good quality, it’s really hard to make a tight fit. Works great on my 85 hp Johnson, not so great on my 25 hp Mercury. I am guessing this is something to do with the location of the water inlet and the shape of the lower unit. I would definitely buy this again.

yes works good quality

I had a couple old timers tell me there isnt a pair of muffs on the market that will push enough water through my old 25hp tohatsu 2stroke, WRONG! Pumps water almost instantly. Awesome product, very tight fit on even my lil outboard lower leg

this product is just a simple way to flow water in your outboard intake , to make sure it is clean and if you want to start it before you go to the lake, product looks very sturdy and functional.

The dimensions of item had me thinking it may fit my Bravo III from the prop side not the back. Unfortunately it doesn't. Works fine the other way but in my situation I can't get to the drive to put it on that way. I am on a lift and the only way to put bell housing side is to kayak over to the boat. Shiping was fine, vendor was fine. product was just like every other.

Perfect - did the job exactly as it was supposed to on the boat motor. Will recommend to other boaters as the one to get.

Works very well ! My previous one was always caused overheating alarm!

Used a big plastic barrel for engine testing, this clamp was so practical and easy to use, love it.

It worked as intended.

The honda 50yp outboard has 3 water intakes(2 on the sides and 1 on the bottom). This is good but wont work for my Honaa motor. I now use a deep bucket to run motor on land.