Amazicha Vivid Black Mid Frame Air Heat Deflectors Trim Left Right Set Compatible for Harley Touring and Trike 2009-2024 Models Without Cool Flow Fan

Looks great.! Just a nice as hogworkz or Harley brand!

Installed them (and they fit) you will save a lot of money compared to Harley and the quality is just the same

Look good have not installed yet

These heat deflectors are hard to install regardless of which ones you buy because the rear head is so close to the frame. But once you figure it out, they look great and deflect the heat.

I was a bit skeptical at first, but for $20 figured what the hell. Now I am super impressed with these. They look amazing! When Harley only offers a matt black set, I knew I needed chrome. These came with almost everything needed to install. The only additional hardware I needed were the U nuts for the top mounting hole on the bike. I purchased them from my Harley dealer, although they can probably be found at any hardware store too. Surprisingly the driver side was much easier to install than the passnger side, even though the bike leans left while parked, there is much more room to work with big hands or fingers than there is on the passenger side. Make sure you have a 10mm wrench to tighten the bolts as even my smallest ratchet didn't fit where I needed it. I still haven't ridden so I can't speak on how well they deflect the heat, but the price is worth it evem for the look. Beautiful chrome finish, and I didn't experiemce any scratches. Total install took 30-45 minutes.

Won’t fit my 2023 Harley Davidson Street Glide Special. I can install left side. I can’t install right side because not exactly like Original Harley pattern. Top screw hole is completely wrong place. See compare with original Harley and that one.

I have a 2012 Street Glide; installation was about like everyone else. I had to run to the hardware store and get 2 nuts and lock washers as only 2 of the bolts came with hardware to fasten to the frame. This proved rather difficult as there is barely any room to accomplish this. It would have been better if I could’ve gotten lock nuts but they did not fit the bolt even though they matched the thread pattern. Also, they work great for me as now I feel almost no heat on my inner thighs however it has moved all of the heat to my passengers right leg/ankle. She wasn’t able to position her leg in a way to avoid this and she said it felt like someone was holding a hair dryer right next to her leg the entire trip. So it seems it’s a choice between unbearable heat on the drivers crotch or the passengers leg.

Let me start by saying these are hands down a great product for a fraction of the cost of the HD version and they come gloss black already. Paint finish is perfect and the fit is perfect. Now for the installation with this you need to be a little handy and patient and be advised you will need 3 nuts as they don’t come with the package and you’ll need 3 additional flat fender washers that also don’t with the package. The left side deflector you use the existing threaded hole in the frame for the top hole and you’ll nut and bolt the lower hole using a total of 2 bolts supplied in the package along with 3 washers and 1 nut on this side. You’ll need to remove the Seat and the side cover and loosen the plastic housing holding the ecm and push it aside to get your fingers in to instal the nut on the back side. For the right side you’ll need 2 bolts supplied in the package along with 2 additional washers supplied by you and 2 nuts supplied by you. This side you cannot use the existing threaded hole in the frame unless you drill another hole in the deflector which would be very hard to measure accurately so the easiest way is the nut and bolt the top and bottom. Remove the side cover and you’ll be able to access the back side of the frame to instal the nuts. It’s a tight fit but with someone holding a flash light and a retractable magnet it’s doable. Great product just be patient you’ll be happy when it’s all done and the money you saved.