39mm Shocks- Aluminum Threaded Shock Adjustable Absorber Oil Damper for Axial SCX24 FMS FCX24M 1/24 RC Crawler Car Upgrade Parts(Grey)

Does what I wanted. Consider this a minimalist way to make your fcx24m better. It won't turn it into a climbing robot which is not what I want for this car so I'm very happy with these shocks. I used top mounting position which will add only a little height vs shorter stock shocks in the middle. Another reason I recommend top/upper position is that these being 39mm vs stock 32mm you will run into drive shaft issues if you try to stretch the fcx24m too high. Using 25w oil, 25% sag, medium springs thumb screw adjusted 75% all the way at the back but only 20% in the front. I'm new to this so forgive me. Drop test and it sits immediately. Lost a star which is harsh, I would have only taken off half if I could: when the car is left untouched for 30 minutes or more the shocks will kind off seize up. I'm ok with that as it's as simple as moving it past that point and they are super plush again. Its only after being parked for too long. I'm sure I will find a work around but I'm not that bothered by it.

I recently upgraded my Axial SCX24 and FMS FCX24 with the INJORA 39mm aluminum threaded shocks, and I’m impressed with the performance. Here are some key points: Build Quality: The shocks are machined from aluminum, giving them a sturdy and durable feel. The threaded bodies make pre-load adjustments quick and easy. Huge upgrade over stock SCX24 shocks. Performance: These shocks use oil dampening instead of friction, which provides a smoother and more consistent rebound. The inclusion of bladder seals helps maintain this consistency. Depending on the install location/angle you may have to do some adjustments to get them to work properly. The shocks are about 3mm longer than stock but I would still consider them more of short travel shock which helps reduce body roll and stability. If you are looking for more articulation and travel go with a longer set. Customization: The package includes three different spring rates, allowing for fine-tuning to match your specific chassis setup. Plus, the variety of colors available lets you match them to your RC crawler car. Value: At $20.99, these shocks offer great value for the quality and performance they deliver. Cons: You do have to assemble the shock mount. These parts are very small and can be very frustrating if you do not have the experience. I would suggest looking up videos to make the install easier. Overall, the INJORA 39mm shocks are a fantastic upgrade for any 1/24 RC crawler enthusiast looking to enhance their vehicle’s performance and appearance.

Good oil shock, I was sent the wrong shocks but amazon made it right quickly. Fairly short travel. I recommend light weight oil like 20 wt or under. I run 20 and it's good. They do stick after sitting at full decompression but you press them down once before use and you are good to go. No stick until you let it sit again. Does not stick when in use.

These shocks are great....but you have to do some tinkering. First they were sticking very bad. So I took them completely apart. Where the shock shaft exits the shock body it has a small plastic ring then a rubber o ring then another plastic spacer then a shouldered plastic washer that lines up with the hole in the screw on cap. What happens is the cap gets tightened and it squishes the o ring and makes them stick. Take out one of the plastic spacers and reassemble them. They work perfect! I actually lost one of the internal parts and they sent me new internals even though it was my fault. These parts are supper small. Like use a magnifying glass to work on them small. It took a few weeks to get the replacement parts but they cam through. I have no complaints. And I run them with no oil and they articulate great and just work good. And there about 3mm longer then stock so you dont have to replace a bunch of stuff to use them. Would buy again. In fact.....I did! Lol!!

Awesome little shocks