Aero Integrated Handlebar Out Front Combo Mount for Garmin Edge Wahoo Elemnt Bryton Rider Stages Dash Hammerhead Campatible with Canyon CEP Cockpits and Wilier Filante Bar Handlebar

Originally purchased the Garmin mount directly from Canyon for $40, and it was great, but there was no way to mount my light to it. This was cheap enough and had the ability to mount my Garmin UT800 headlight to the bottom.Is it as sexy as the OEM Canyon mount? No. Does it work well? Yes.It's very sturdy aluminum, and has a rubberized strip where it touches the carbon fiber, to prevent rubbing/noise/damage. It came with 2 small washers which I had to put under the light mount to prevent the screws from bottoming out, but then didn't have any washers for the 2 screws that attach the mount to the handlebar. Luckily I have a collection of zillions of small bike parts that I've gathered over the years, and had 2 washers that fit perfectly, but keep in mind you may need 2 additional washers to mount this properly if you're going to mount a light as well. I like that the light mount is behind and not directly underneath the computer mount. Better balance, although this feels sturdy enough to be fine even if it was out front.The only issue is that the light is bolted on, and not a quick release like the out front mount that comes with the light (which doesn't fit on my handlebars since they're not round). So I have to unbolt the light to charge it, or get the bike close to a power outlet if I don't feel like removing the light. A minor inconvenience but a quick release or the ability to add one would be cool.Overall, solid, cheap, and works well.

This mount fit well on my Canyon Grail, allowing a Garmin 830 head unit to fit close to the front of the lower bar -avoiding unnecessary overhang. The design of the under mount for a light is better executed than other similar products. First, it positions the added weight of the light at the mid point; this reduces the stress on the bar mount points and will reduce vibration of the head unit over rough surfaces. Similar products have had complaints about breakage across the bar mount slots, the total weight at the far end is a likely contributor. Second, the light mount detaches if not needed.When mounting to your bars, check to see that mount does not have a small bend when tightening the screws (creating a pre-stress). I had to add a thin rubber washer (like a thin faucet washer) under the back screw to get it to lie flat.

This part is extremely well made, sturdy and looks very nice on the bike. One slight flaw that I came across for my Canyon handlebar (CP07) application was that my Garmin 1030 GPS computer was placed too close to the handlebar. Pressing the two bottom buttons is a little difficult, especially with long fingered gloves. If the reach was extended by 3/8" it would be much better.

We’ll machined aluminum product. Very sturdy

I had to use some thin washers under the go pro mount because the included screws were bottoming out before it was tight. Other than that it fit great. When I get my gopro adapter for my Fenix bike light it should work great. I had the light mounted on the bars before and a lot of the light was blocked by the bike computer and my bar ends. This is a much cleaner setup.

Why spend the extra money..works perfect in my Canyon..

Nice mount, but no instructions so you have to figure which of the three adapters fit your computer. I have a wahoo bolt and it work great

It fit my Canyon CP30 handlebars perfectly. It has a polished metal feel.

The media could not be loaded.  Item received well packed and shipped fast. Good quality and as advertised. Thank you seller, highly recommend

Bueno

BUENA CALIDAD

Good mount. Solid built, doesn't bounce or vibrate.

This product is very good for race bar. It is so stable.