• For the Traxxas T-Maxx 2.5R, T-Maxx 3.3, E-Maxx 16.8 and Brushless versions.
• Can be adapted to work on earlier versions such as the T-Maxx 1.5/2.5, S-Maxx and earlier E-Maxx versions.
• Serious strength and rigidity while the make up of our proprietary blend of nylons provides unmatched durability.
• Backed by RPM's world-renowned breakage warranty.
• RPM is a proud American manufacturer designing and manufacturing 100% of our molded products right here in the United States.

From the Manufacturer --------------------- The RPM True-Track Rear A-arm Conversion kit eliminates one of the biggest headaches associated with the incredibly popular Maxx line of trucks. Rear toe angles are nearly impossible to set accurately and there isn’t a gauge currently made that can tell the T-Maxx / E-Maxx owner if each individual wheel’s toe angle is set correctly in relation to the chassis. Our rear end kit completely eliminates the rear toe link, locking in the rear toe angle at a solid negative 1.5 degrees per side for a total rear toe of negative 3 degrees (of Toe-In), effectively eliminating rear bump steer. Our design retains the stock upper pivot ball in the RPM axle carrier to allow precise camber adjustments while the lower pivot ball has been eliminated in favor of a rock-solid, beefy 4mm diameter hinge pin that locks-in the rear toe angles for race winning consistency. All aspects of the RPM rear end conversion have been beefed up for rugged durability and slop free movement throughout its range of travel. We’ve completely redesigned the rear end yet all stock suspension geometry has been retained. Additionally, we’ve incorporated our oversized bearings (3mm larger in diameter than stock) into the design, providing 2mm more bearing contact with the axle while doubling the bearing load rating and tripling the igue rating over stock bearings. So does all this add weight? Not a single gram. The entire RPM rear end kit weighs in at exactly the same as the stock components that are replaced. What’s Included: Our rear end kit consists of two upper rear A-arms, two lower rear A-arms, two beefy rear axlecarriers, two outer 6x15mm sealed bearings, two inner 12x21mm sealed bearings, two aluminum pivot ball setscrews, two delrin pivot ball bushing cups (with more than twice the contact area on the pivot ball as stock setscrews.), two 4mm diameter tool steel hinge pins and enough e-clips to get the job done (4 minimum).