Damexsoundcore Life q20 Replacement Ear Pads,Protein Leather and Memory Foam Ear Cushions,Compatible with Anker soundcore Life q20 BT Headphone (Black)

I don't know how long these will last, but first impression is great. Perfect fit and a plastic pry tool is included to make removing the old pad's plastic frame easy.To install, peel off the old foam pad to expose the supporting plastic frame. Then use the pry tool to release the tabs holding the frame to the headphone. Align the new pad (look for a small pin at the top) and press the pad firmly to lock the new frame's tabs into the headphone.

I got these replacements for the pads on my Anker Soundcore Space NC headphones. I'd read that the Life Q20 pads also fit the Space NC. It took a little work but they did fit and seem like near-perfect replacements. They are slightly thinner than the original pads but feel fine on my ears.Removing the old pads wasn't too hard. These came with a spudger tool but I used a couple guitar picks instead and they popped off the clips. There are six clips around the inside ring of the pad.Putting the new pads on was a bit more difficult. First I had to snip off the alignment peg which is in the wrong place for the Space NC. Easy enough. But the six clips are kind of a tight fit. I found that starting at the bottom of the pad worked best for me. If it's too hard to get the clips in, rotate the pad slightly and try again. Work your way around and eventually you'll get all six clipped on.

I was disappointed when the original Anker pads failed so quickly (as a pair at the same time). But these pads fit perfectly, were very easy to install (less than a minute with the included tool), look like the originals, though might be the slightest bit slimmer and were very inexpensive. Time will tell how they will last. Satisfied!

Great oem fitment. Wish they sent new foam for underneath, but you can reuse the old foams (just don’t clean them too hard). But these ear cushions work great.

Using the small plastic tool included with this the old headphones just pop off and these just snap right back in. This could not have been a more simple solution. Total time had to be less than 5 minutes.

Todo lo esperado buena calidad y a tiempo muchas gracias

Needs a little push to get in. Although thinner than my originals. I also learned my headphones don’t have those white pads. Anyone know where I can find a replacement for the top part of the headphones?

This product fits perfectly with my Soundcore Life Q20 earpads. Since I wanted to mix and match colors, I chose silver earpads which I'm quite happy with. I compared the original earpads with the new ones, and while there's a slight difference in sealing, they match almost perfectly, so much so that it's not an issue in my opinion.First, using the trim remover provided with the product, I separated the headset and earpads. It's important to note that since there are six links connecting them, it would be better to separate them by sliding the removal tool gently in a circular motion rather than trying to do it all at once.Once the earpads are separated, you can see a thin white spacer located between the earpads and the headset. This spacer doesn't come with the product, so make sure not to discard it.Due to the speaker profile of the headset, it's necessary to distinguish between the right and left sides of the earpads. Fortunately, like the original pads, the new pads also have "R" and "L" markings for right and left, making it easy to reinstall them. When installing the pads, make sure to place the stored spacer in the oval hole and then attach the links one by one while pressing down on the new pads.I believe this product is perfect for replacing the worn-out pads on the Q20 headset. The pads themselves fit perfectly, and the product quality is good. However, the only drawback is that the memory foam inside the pads feels slightly thinner compared to the original pads. This difference is noticeable when compared directly, but it doesn't pose any problems for using the headset, and it's comfortable, so I'm satisfied with it.