80 Pieces 8x1mm DIY Personalized Multi-Use for Fridge Door Whiteboard Magnetic Map Magnetic Screen Door Bulletin Boards Refrigerators Round Cylinder Magnets

The media could not be loaded.  These batteries are perfect to replace ones lost from a Kit Kat Clock, responsible for the eye and tail movement. I tried magnets of unknown strength (they were the same shape) with no luck, but the ones recommended do the job. They are really strong and would be good for diy fridge magnets.

The Price is Great. Strong little magnets. Works Great for my Purpose. Happy Shopper....:+}

I used these for closing layered paper pockets and despite three layers of paper they hold strong and are barely visible. I wish I'd discovered them sooner!

The magnets are of fair quality for the price. They are decently strong, and they can hold a good amount of force for their size, but I did run into the problem of them breaking unless you controlled the force in which they stick together. I've had multiple magnets from this pack turn into tiny shards due to this issue. So if you do purchase them, just be careful when joining them together.

I bought a We R MemoryKeepers stamp positioner several years ago before Misty sued them over the patent? One of the differences between them is there are no magnets on the back of the positioner. Thanks to a YouTube video, I found these 8mm magnets fit perfectly! You need to mark them with a Sharpie on the same side so you don't reverse the polarity before you glue them in. Now I need to find a cheap bar magnet and I'm set. Thanks Amazon! Note: these magnets are delicate. I had one break, so I put one-half in one hole and the other half in another hole.

Arrived on time and was what I expected, as it should be. I will order them again in the future and will recommend them to friends.

I bought these magnets to embed in a 3D printed drone model (Destiny Ghost on Thingiverse) I made as an xmas present. Something like 24 magnets were used to hold the parts of the model together. Two of these magnets (one on each side of the part), were not strong enough to hold the model together reliably, and the smallest bump would cause the model to fall apart.I ended up reprinting the entire model, and buying some 6x2mm magnets. Even though the new print was a bit bigger (hence the parts slightly heavier), the 6x2mm magnets worked fine, where these 8x1mm magnets failed.They may be fine in other applications, but for me they were just too weak.

Excellent magnets. Used between 2 cardstock papers and works great.

Was perfect for what I needed it for

Purchased to place a poster on wall without pushing pins through paper. These are not strong enough (one in each corner to hold a post in place.