GIANTARM Silver PETG 3D Printer Filament Toughness Enhanced 1kg (2.2lbs), 1.75mm Dimensional Accuracy +/-0.03mm, 1080 Feet（330m)/Roll, Vacuum Package, Fit for Most 3D FDM Printer

Prints really well on my setup with pretty basic settings. Color is good and came in very good condition as for as moisture goes. The only reason it isn’t 5 stars is because the spooling was a little tight. Continually got snagged, so I was forced to re-spool it.

Not the best but also not the worst. I printed it from my A1 and I knew I was going to have to slow it down, but to get really good results you have to print it very slow. The color was consistent and fantastic. I gave it 4 starts because I have printed other brands PETG which are slow, but not as slow as Giantarm.

I didn't really know what to expect with this, but I've been printing it with a profile meant for generic silk PLA, and it has consistently produced great prints. I'd say it's good value, especially when on sale. The only actual issue I've had with it is that it seems to melt a bit differently than other filaments I use, leaving thicker clumps when purging than what I'm used to, and this has lead to large chunks of it getting stuck by my nozzle wiper a couple of times.

This is the best PETG I've printed with. I'm sure there are better ones, but this Giantarm filament prints great and smooth. I've only really had experience with a few other brands of PETG before this and it didn't print very well even after drying it forever. But this PETG is great and it sticks to the bed well. The prints came out fantastic and didn't have any trouble with it. If you're on the fence, try this one!

I printed right out of the package without drying. There was no stringing. The bottle openers I give away have plenty of strength. After physically stressing them, they returned to their original shape. The lettering was as sharp as expected for a .4 nozzle. There were no overhang issues on the hands and rocks. I used Bambu's generic PETG profile with no modification. I will buy again.