GonineCP-W126 Camera Power Adapter DC Coupler Kit for Fujifilm Fuji X-A1 X-Pro1 X-E3 X-T1 X-T20 Digital Cameras(NP-W126 Dummy Battery Replacement)

My main use for this is to use my FujiFilm X-T20 as a webcam for streaming and it works amazingly. 9 volt 2 amp plug is the perfect plug i was looking for with the dummy battery. The X-T20 still heats up after about 2 ish hours of use but by turning off the lcd screen and moving the screen so it's not touching the camera itself it helps reduce thr heat build up significantly. I tested the battery for 4 hours on Sunday and it didn't turn off at all and tested a further 7 hours the next day with the room also being heated and still the camera stayed on.If you're looking for a great dummy battery for your FujiFilm that's listed in the products image previews then look no further.

The cable coming out is too large to fit through the channel in my battery door, so the battery door has to be open. Which would be fine if the tolerances were good, but sometimes if I’m moving the camera around the battery drops away from the contacts and I lose power. You’ve normally gotta give it a little poke and to reseat it.

The camera will power off frequently because the dummy battery connectors lose contact with contacts in the battery compartment. When pressure is applied the camera will power on. I could _just_ get the battery door to close and hold things tight enough but it does cause the door to flex a bit which I also dislike.

I bought this so that I could photograph birds from my window without using battery power and running out for the best shot of the day. It is very simple to use - just plug it in the mains and slot in the dummy battery - no problem running out of power. Great value for the money.

Does the job as listed but I think it's over priced