WEWU ROUNDS12" LP 7" EP Vinyl Records Bracket for 6L Ultrasonic Cleaner Simple Version(No Ultrasonic Cleaner)

Exactly what you need as part of an ultrasonic cleaning set up. Turn very slowly (the one I have is less than 1 RPM) and extremely well built.

I have an extensive record collection of LPs, 45s, and 78 rpm records. I have been collecting records since I was 5 years old, and I still have some of them. Over the years, I have tried all kinds of surface cleaners and brushes and solutions that made the record look nice, but the sound quality didn't improve very much. Along came CDs, and my record collections just sat on the shelf, hardly being touched, while I started to establish quite a CD library. Everyone talks about the warm sound that vinyl has compared to CDs, (and I remembered that back in the day) but when I dug one out and flopped it on the turntable, it just didn't have that sparkle and clarity that I remembered. Plenty of clicks and pops and surface noise were still there, growing it seems while the record was in its paper sleeve. I was getting ready to put the record collection up for sale to get rid of the clutter, but thought that I should make an attempt to shine them up to make them more appealing to the buyer. As I said, I had used all kinds of record cleaning cloths and devices that didn't really make much difference to the sound quality. So I decided to give it one more shot and looked at what was available on Amazon. I knew ultrasonic tanks were one of the best deep cleaning devices on the market, but I had never even considered it for cleaning records. The tanks were a little pricey, but not out of my league completely. Then when I discovered this record turning bracket I thought it would be a necessity in this cleaning process. It had good ratings, looked nice and sturdy, so I decided to give it a try. This does not come with an ultrasonic cleaner, it merely spins the records slowly while the ultrasonic sound waves do their job. I was concerned about the labels getting wet, but the water seems to stay within the grooves of the record and don't ever run across the label. There are many ultrasonic tanks on the market, so after a lot of research, I bought one priced close to the cost of this spinner. That brought the tank and spinner up to around $300, but when I priced the sets that included the tank and the spinner together, they were much more.I set everything up, filled the tank with filtered water, set the timer for 5 minutes, and starting cleaning. After they came out of the tank, I dried them with a microfiber cloth, and built a drying rack to let them dry thoroughly. When I put the first 25 year old record on the turntable, I was absolutely blown away. Gone were the clicks and pops from surface noise, and because ultrasonic cleaning goes into the groove and removes all that dirt and dust that was packed in there, (that I had forced into said groove while I thought I was doing the record a favor by wiping it with all kinds of brushes and rags) the fidelity was unbelievable! I have always taken care of my records, but they still sounded like old records do after awhile. After cleaning them, I could not detect any surface noise at all between cuts. It could have been a CD I was listening to. After running about 200 LPs through the process, I started on the hundreds of 78 rpm records. They clean up so well, that there is hardly any surface noise at all. Suddenly I was hearing the fidelity of this record as if I had just bought it brand new.Bottom line: I have run over 500 records through the tank using this unit, and it continues to operate flawlessly. It is definitely worth the money, in my opinion. Yes, yes, yes, buy this unit and get an ultrasonic tank as soon as possible and get ready to be amazed by your record collection again.

I use this on my ultrasonic cleaner for cleaning my records,but the thing is,is that with the supplied 12v adapter it spins at 6 rpm,which a bit on the fast side and also somewhat noisey,so what i did to fix both the noise and speed issues was to simply buy a 3volt ac/dc adapter to slow it down to 1 1/2 rpms,its now super quiet and slow which is better for cleaning your precious vinyl.And the 3v doesn't hurt the unit at all,it runs very cool,no overheating what so ever, and the 3volt adapters run around about 6 or 7 $,so again isnt that bad, over all this thing is built like a tank plus it mounts really securely on my cleaner,just make sure your tank is at least 11.8 inches accross or the record may not fit

The media could not be loaded.  If you want to get the best performance out of your records, ultrasonic cleaning is your best option for older, dirty records. I have found that nothing cleans records better, and yes, I have tried many different ways to clean them. I recently acquired a large collection of older records that were stored in a garage for years. Many records were extremely dirty and ultrasonic cleaning worked extremely well.Since I already had an ultrasonic cleaner, I went with this unit. It is simple, well built and works well but suffers with some limitations.The good:It is extremely well built. It's case is solid and the motor and switch works smoothly. The mount is simple with two screws for attachment, and the included backplate helps from denting the ultrasonic cleaner. The label protectors are fantastic and do a great job protecting labels and are just the right size for my 33rpm records.The bad:The motor does indeed turn too fast. I was able to mount a speed controller to the unit easily enough, but would have been nice if already equipped. The unit is not great if you want to clean 45rpm records. The adapter it comes with looks nice but because it is made of soft metal, the tabs bend too easily and doesn't hold the record very well. Also the 45's do not extend far enough into my ultrasonic cleaner enough to be effective. I have to fill it to the brim to cover all the tracks and I don't like that. And the label protectors are too big and covers the inner tracks a bit. This unit was definitely designed around 33rpm records. Lastly, it can only handle two records at a time and wish it could handle more. But I knew that when I bought it so that is on me.Overall, this is a decent unit for someone who needs to clean some records and already has an ultrasonic cleaner. With some small modifications it could be so much better but for the price, it works well as it is.

I ordered it on Monday and it arrived on noon on Tuesday!! It came well packaged and the presentation was professional, it felt like I was getting a b'day present! Plugged it in and it works alittle loud but should be less than the US machine. I will give it a good test tonight. So far it looks great, well made and I would recommend to others!

There are very few options in the market for a spinner to deep clean LP records using an ultrasonic tank. This one is a very well thought of, well designed and well executed piece of aluminum machinery. I echo all the positive reviews. The included wall wart is 12 Volts, but it makes the spinner rotate fast and LOUD!. I use a 5 Volts instead and now it spins slower and SILENT!!!! You can clean two records at a time. I set my ultrasonic tank at 15 minutes, that's all you need. Highly recommended and the price is right for the quality you get.