Table Saw Blade, 10 inch, 80 Tooth, Fine Finish, Ultra Sharp Carbide (DWA11080)

Almost a year later and the blade hasnt needed to be sharpened and still makes amazing cuts. Ive been able to make some fine cabinets with this blade and it held up great. Much cheaper but good quality compared to other brands.

For the price this is an outstanding blade. Very smooth and easy cuts. I have one on my table saw and miter saw.

Excellent for fine cuts.

This is going on my table saw and it's a decent blade. Out of the box it cuts justs fine, one weird thing is that more saw dust comes up from the back and onto the table than the previous blade. No idea why as it connected to a vacuum. I've cut about 400 feet of one inch oak so far with it and it's still going strong, but I don't think this will last as long as my better blades. However, at this price point, it does a really good job. Good clean cuts, it's sturdy. Overall: If you cut softwoods, it will probably last a very long time, it's holding up well with oak. I'd buy more because the value is excellent.

Really good blade, fine enough to leave a reasonably finished edge, but coarse enough to to cut with speed and not burn the wood. I've also used this to cut PVC pipe, leaves an almost factory end.

I bought a Skill table saw earlier this year after debating over a dewalt. The saw is great but the stock blade was horrible. I replaced it with this dewalt blade and it cuts through 2inch red oak like butter. The stock blade was 24t vice this dewalt 40t. The price is low and it’s great quality

I've bought this blade before and got good cutting for a good while with it. Hope this one holds up just as well.

Good replacement blade

Cortes muy limpios , recuerda usarlos uno para corte de madera y otro solo para melamina y duraran más 1 año con uso diario y aún tiene filo

As Described

Cumple al 100% las expectativas de corte

Hace cortes muy limpios

I replaced the original blade from my sawstop with this one, and it's been really good - I don't get burn marks unless I'm cutting thick lumber and if I'm making small furniture and cutting timber panels / plywood there's virtually no burn mark and the cut surface is really smooth. Take 1 star off cos it does still have a bit of burn mark when used on thicker materials.