WSOOX1/4 Inch Shank Rabbet Router Bit Set, 3 Pieces Rabbeting Router Bit with 6 Bearings Set (1/8", 1/4", 5/16", 3/8", 7/16", 1/2" Bearings) (1/4 Inch)

I used the 1/2" Rabbet bit on some 1 1/2" southern pine and fluted both sides. In total, I routed 2,432 feet and the bit never seemed to slow down. The last pass was a clean sharp cut and as nice as the first. Great carbide on these bits. Worth the money!

First time using it and had no issues, amazing price and options. A third of the price to lowes and home depot options but for the first try it's working amazingly.

Needed a 1/2 bit for rabbit. Ordered one afternoon and had it delivered next day.Did a good clean job and inexpensive

I needed the extra bearings to get the right fit for my cabnet doors. The bearnings were easy to replace and bits were sharp. High quality product. I would purchase again.

Routing dadoes.

Used this router to enlarge the hub diameter of 4 aluminum wheels. It worked perfectly, the fit was excellent, and the router still like new.

Needed some cheap router bits for a project. These fit the bill. Dull by the time I put a dado in a long board of pine for a window frame. Expected poor quality and they delivered. Perfect for the job i needed

I was doing dados for some boxes and used them on my router table. Bearings helped for the depth. Good price too.

Funcionan muy bien, buen producto

Used it to cut a groove in five oak shelf. Did it without leaving burn marks in the wood

Used quite a bit, seem ok so far, are strong, sturdy and sharp would recommend.

Así quedo la fresa después de como 25 mt lineales de rebaje a una madera se ve bien y no perdió el filo, el problema viene que cuando quise cambiar al balero se barrio la llave ale y tuve que hacerle con el esmeril de corte un corte para utilizar un desarmador y poder desmontar y montar el balero.Le quito una estrella por la llave ale y de lo demas la veo muy bien

I read the reviews for these and thought I'd take a punt. Intended use was clean up for existing rebates in Oak, taking about 1 mm max. Front cut OKish, but top cut absolutely terrible, almost set fire to the Oak. Close examination after only 200mm of cutting and I've seen sharper bananas! I've checked one of the bits I haven't used and the top of the cutter wont even scrape a finger nail. Maybe OK for pine.