CRJ 15-Pin SATA to 2 PC Fan Power Adapter Cable - 12-inch (30cm), Black Sleeved - Power Up to Two 3-Pin & 4-Pin Computer Cooling Fans from an ATX 15-Pin SATA Power Connector (12V - Full Speed)

I had just finished building my sixth gaming PC. Using the MSI Z790 MAG Tomahawk motherboard the MSI MPG Velox 100r, I had a case fan wiring issue. The case fans and their wires were not the problem, the snag was the location of case fan ports on the mobo. All fan ports (except the exhaust fan) were at the direct bottom of the mobo. Using the two fan splitter helped but I was still left with a mess of wires. After doing a quick bit of searching, I came upon this. I was unsure but decided to give it a try. Best case it would work like a dream; worst case it was defective. Turns out it was best case after all. I connected all four case fans to the splitter, then connected it to an extra SATA cable port on my PSU. Wires are managed behind the mobo with all the wires and my fans are doing fine. I’m already happy with this so I ordered a two fan pin splitter. I’m getting ready build a friend his PC and that splitter will come in handy for his 240mm AiO.

SO FAR SO GOOD, My ITX motherboard only had one fan header and for my nas in a small case i wanted to maximize air flow. There are lots of opinions out there that say you shouldn't use these adapters and heck they may be right but its doing the job perfectly for me and i expect it will for you too.

Nice sheathed power cables, working perfectly. They're full black so they look great in my PC. Just know they don't have PWM control, so the fans connected to it will be spinning at full speed.

nice merci

I have a gaming PC that has a custom setup where the fan and RGB lights are all on one connector. One of the fans was getting noisy. I bought this cable and 4 pin fans VIOLA no fuss install and no lights (not a fan of the distraction they have for where my PC is located.