Assembling Instruction 1, The controller is put into the controller casing. 2, The power cable and the motor feedback wheel clamps are attached by kapron swingarm. The plant is inside the controller cover. 3, The battery - Mounted inside the battery casing, together with BMS. Battery fixing by belt. 4, For wiring of the rear and the front lighting frame, can go through the hole with a diameter of 20mm 5, The ignition switch has two positions. Recommended components for assembly 1, The rear shock absorber: cycling, spacing of 200mm 2, Fork: Front diameter 1-1/8”, dropout of 110mm or 150mm; 3, Motor kit from 1000W to 5000W motor rear wheel. 4, Seat Post Size: 25.4mm diameter.
C**.
Dangerous.
Save your money!!Paint chipped off, even just during installation of components. The steel hasn’t even been prepped or primed, just sprayed with cheap paint. The swing arm pivot isn’t fixed, it’s some cheap rubber bush mount where on a proper bike, a pivot bearing would be. The bike itself is held straight (ish), (due to nasty pivot), solely by the rear shock absorber.Rear gear selector mount: Hadn’t even been threaded.Key switch: Came with corroded solder joints.Frame assembly: Nasty gaps in the frame where water will get in and rust. Terrible paint job. No stability. I even had to drill out the holes for the seat assembly to fit, as the steel underneath was overlapping where the bolt would slip through.I’d send this back if I hadn’t already modified it to try and fit the seat. I should have known.I paid ~ £350 shipped to UK, and disappointed is an understatement. I wasn’t expecting miracles for the money, but it’s now just £350 down the pan. TO THINK PEOPLE MAY BE RUNNING AROUND ON THESE WITH A 5000w MOTOR!!!Terribly built and dangerous.AVOID!!!
A**R
Don’t buy !!!!
Badly made Chinese frame and horrible customer service
Trustpilot
3 days ago
2 months ago
