6"x120" ARMOR UP PPF film

I’ve had prior experience with this product. It does the job and because it’s 8 mm thick and self-healing it protects your car paint from rocks and road debris. It applies easily and bubbles come out easily.

I used it on my matte bike after I realized that scratches cannot be removed by buffing like with glossy finishes.I was not expecting it but once I applied this film, I could no longer see the scratchesThe application was not so difficult but the film sticks strongly, even using soapy water. It is easy to stretch so that helps a bit.Overall totally recommend this, bit pricy but much better value than frame protection kits.

A learning curve to correctly install but this is doing it's job.

Easy to put in and save some damage

I usually run a solo seat on my bikes and had past experience of a two up seat scuffing the rear fender. I put this film on the fenders of both my bikes and tanks where the seat touches and you dont even know it's there but it protects the paint perfectly.

This worked out until it did you have to keep moving the product to make it work perfectly but if your hands have anything on them, you’ve ruined the product because it would end up on your car so I had to just pull it off

This came packaged in a tube to protect the edges. This also had clean factory cuts.

Film ends up cloudy after application. It's not moldable, and doesn't shrink to fit (heat). I bought a vinyl table cover with gumming, basically. NO REFUND ELIGIBLE. So just make sure what you want protected is flat/straight and you can cut around it (no tucking in excess).Pro:1) easy to apply on flat/straight surfaces.2) perfect thickness for great protection.3) east to removeCon:1) backing is white (not transparent like others), so it's hards to line up, cut, and fit before sticking it on (can't see through it until I remove backing to expose gumming)2) Too thick to mold, and go around grooves/concave/curvature.3) Doesn't react to heat, so it won't bond or shrink for right, and tight fit (like shrink wrap). Great for square/flat panels or lights but you must cut it exactly! I had 1 cm at the ends i tried to tuck under my lights/frame, but it kept unbonding and Popping out even after heating it.4) end result is a cloudy lense (headlight). So it would be fine for colored surfaces, but it clouds clear headlights a little bit. Product is thick so it adds to the turbid shear/haze, but in all fairness, maybe my soap/water ratio was off?I wish I could get a refund for a cut up used product :(. It is NOT a bad product, just bad for me and curved headlights. JUST NEED BETTER DESCRIPTION/RECOMMENDATION.