Crazepony4pcs 6x15mm Motor (Speed: Insane) 19000KV for Blade Inductrix Tiny Whoop Micro JST 1.25 Plug

Good motors, probably a little hotter kV than I required, but works with limiting throttle range in transmitter.

They need a pretty small prop and they will get very hot if the prop is too large. They are extremely light weight and work fairly well. Given 4.2 V They draw around 2 amps at stall and 0.1 amps under no load. The only drawback I had was 1 of the motors gave much more power than the others needed to regulate this in the programming.

best brushed high kv motors i’ve come across, available on amazon. other Apex RC products appear to be manufactured with poor quality. these motors from crazepony have a higher gauge wire and appeared to be of better construction. with any brushed motors life is short, but these lasted twice as long as cheaper brands and without heating up too much during flight. the other 19500 kv motors used to heat up like crazy. i will say however that the plastic base of these motors appears to be quite soft and/or brittle. it feels as if smaller prop strikes or crashes break motors more quickly than other brands. this is consistent across different kv models so appears to be a manufacturer difference.

This was a great upgrade for my blade, while it lasted. They made my quad noticeably faster and responsive. I had to get different props as well due to the shaft diameter. My battery life took about a 30% hit, but these draw more not including any prop difference.All was great for the first 45 minutes of flight until I hit a wall, mid speed, and the bottom of one of the motors fell out. I was hoping I could plug the unit in as it came out whole but during my examination the plastic holding the wires crumbled and there was no chance.So 5 stars for the first 45 minutes.3 stars because all I got was 45 minutes after a crash that shouldn't have caused the connector to crumble.

So, I have this self-flying drone purchased for the grandkids. Worked very well but with a bit of abuse one of the motors crapped out. After some measuring of the original motors I found these that appeared to match what I have, ordered them up, arrived looking good and were installed. The value for the money is very good. The 5 star easy to install description is accurate for me but if you're not experienced with dismantling small electronics like a small drone and doing some soldering on a small scale to install all four motors then it may be a bit more tedious than expected. But the drone is back in the air.

These are good motors for the price. Ive purchased motors that cost more and are at higher rating, they perform about the same. This motor gives you more thrust enabling you to increase altitude faster or recover from a flip. It can help with cornering as well since the motors are very responsive.One thing to keep in mind is that your flight time will be reduced. My times reduced by 35-40 seconds which is no big deal to me. I usually get 4 minutes with 14k motors but the speed is a boring 4 minutes. HV batteries may help increase it but if you are satified with a bit shorter flight times then hv might not be required.Ive purchased several products from Crazypony and not one has given me any problems! Definitely getting more parts from them when i need it!

Ordered the wrong motors for my drone but still good motors maybe I'll get a drone that uses this size of motor or even use them for something else later on.

I had used these motors and the 17500kv ones before but I had a car accident a d left with a spine injury then my father passed so I gave my cousin my tiny whoops.Well I decided to build a few and fix a couple I had sitting around collecting dust.I bought an Blade inductrix fpv pro board,a 65mm cockroach frame and used 3 blade German props.WOW!!!!Tons of power,it's super fast but yet smooth.I ended up changing the connector and bought some 1s HV lipos.Smashing this thing In the air looking like a hummingbird on crack.These motors can't be beat for the price.I highly recommend these motors for your tiny whoops.I also bought an inductrix fpv board slapped on these motors and a fpv micro camera and these motors have no issues carrying 28.40 grams with plenty of oomph when needed.I bought extra to keep as backups.I hope they never stop selling them at this great price.