AKK KC04 5.8G 600mW FPV Transmitter 700TVL 2.8mm 120 Degree FPV Camera for Racing Quadcopter

the camera is good for long range

I had a hard time finding a good fpv camera. This worked perfectly.

I have purchased two of these kits, both are ground based units. Line of sight reception range is great in high power mode. First set works great for what it's mounted on. (Inspection vehicle) Second set has an overheating issue with the camera. After 8 minutes it fails and only static from the transmitter. I've swapped cams between the vehicles, TX stayed. Problem followed camera. Test your purchases on the bench before your 30 day expires as failures can happen. I'm not mad, I need a wider lens anyway on this unit.

Great seller and price 👍

I had a hell of a time getting this guy to work. Both VTX AND Camera need 12v to operate. I had kind of a flaky PDB that was outputing 9.something volts on it's 12v output pins and the VTX was blinking on and off. It's now connected directly to the 3S battery input (stacked on top of the battery leads) and seems to be working quite well! I may add a capacitor on the cables to try and smooth it out further. Regardless of if you have a PDB with 12v out or not, the camera I received would not operate off of the 5v out supplied by the VTX via the servo connector and the camera needed its own power run. The antenna is going to break very quickly too I think on my buddy quad. Maybe okay on an FPV plane though.

It was good while it lasted, I burnt it out but it was my fault

So far, great range, super clear image, not the widest angle, but very little fish eye distortion, great for fpv. Soldered it to my power distribution board and have it running off of my quads battery. Will update of anything changes.

Excellent video quality. Like others, I've discovered the running voltage is not 5v. If you try to run on a 5v source (like 4 AA's) you'll need fresh batteries that output 6v. Under 5.2 volts the camera will not power up.

Awesome

欠品もなく、商品もきれいでした。 ６vでは動作がシビアで、弱った乾電池では映りません。 安定させるには、しっかり６v以上は必要です。 ただ、基盤が熱くなりやすいです。 画像は明るくキレイで、シャープです。 動きに伴う、ちらつきもありません。 良い商品です。

This is a very robust FPV camera for my drone but the exposed PCB is a bit of a concern. The transmitter heats up during use so airflow is necessary. Attaching a heat sink might be worthwhile.

VTX seems to work and connects to monitor but shows black screen. Assumedly because camera not working on arrival.

ラジコン飛行機です