I clean Filters Replacement Shark Rotator Powered Lift-Away XL Capacity NV755, 2 Foams & 2 Felt Filters Kit Compatible with Shark NV755, UV795 Rotator Lift-Away Vacuum Cleaner

My Shark is like a brand new one.

Just want to note that I have not been compensated for my review in any way.The filters appear to be of good quality. They fit in my UV795 purchased at Costco.The plastic fine filter is very close to the original. The walls of it appear to be a tad thinner but I do not have micrometer so I can’t confirm. It fits just a bit looser than the original but should seal regardless of the fit since there is a rubber seal around the perimeter.The smaller round filter is thinner than the original and made of a different material. The tabs are glued on instead of being sewn on as on the original. The original filter let through very fine dust which was captured by the final filter. I have not tried the new one yet and will update my review with notes on that later. The filter fits well and of the correct size. It is hard to judge exactness of the fit with the foam filter but it covers the opening well.The tube foam filter is shorter than the original by about 5mm. It however covers all the openings on the filter holder so shortness should not be a problem. The picture shows the size difference. The foam filter is somewhat of a tight fit on the holder. Could be because it is new or could be that the opening is a bit smaller. It does go in however and I expect it will loosen up with time. The foam is denser than the original filter and it is harder as well. I feel that it should perform better being a denser foam.The filters take a while to dry out and therefore I would recommend to purchase additional set. The price of this filter set is much better than the original from Shark and if it performs it is definitely worth purchasing.I will update my review with the performance after I use the vacuum.

Foam was about 1cm shorter than original. To use i have to place it on the unit and hold it short, covering the air holes but not all the way down to the bottom. As the foam ages and stretches out, this will no longer work since the foam will slide to the bottom and no longer cover all the air holes.After a few months use - the foam has decompressed from being in the package and fits perfectly! it has bee so nice to be able to switch out the dirty filters and keep cleaning.

It fit my vacuum and was a good value.

Fits my vacuum well but it is not quite as thick as the original filter so there is a lot of dust and dirt buildup on the outside of the filter in the bottom ring where it sits. Also, getting a lot of dust on the outside of the machine. Otherwise would have been 5 stars because it is a good product at a great price.

These worked out great for my Shark LIft away. I have to replace mine every couple of weeks since I live on a very dusty farm and have two dogs that shed alot. I toss the foam filter along with the small round filter into a bowl filled with a bit of homemade carpet shampoo, and it comes out great. If I need more I will def be ordering from this seller.

N,/a

Fits my Hoover wind tunnel exactly and was easy to install. Was way overdue to replace my old dirty filter.