Adjustable 304 Stainless Steel Duct Clamps Hose Clamp Pipe Clamp Air Ducting Clamp Worm Gear Hose Clamps (10 Feet，8 Pack)

I bought them for my backhoe and they did exactly what they're supposed to do. I like it that you can cut them to length and make it a certain size.

Was putting up a pipe for a birdhouse. Decided to attach to the post of a chain link fence. Needed more than 9 inches of clamp band which was impossible to find plus the cost would have been crazy.Ordered this set from Amazon, was able to cut off the lengths needed and still have more left. Used two of the screw parts with 4 left over. This did the trick, the post is up and secure and my cost was reasonable.

I used this product to anchor a heat exchanger fan in a homemade laminar flow screen. Box.Worked well but the clampscrews are reverse threaded which led to difficulties with assembly.

Make your own huge clamp. Cuts easy. Slip in a cinch and screw it home.

This is a pretty sturdy hose clamp kit that allows you to make your own hose clamps from small enough to hold a radiator hose on your car, to big enough to wrap around a basketball (or even bigger). My best advice is to SAVE THE DIRECTIONS. This works VERY well, when done properly. However, if you look carefully, the slots in the band are cut at an angle. Now, look at the tightening screw, they are also at an angle. If put together wrong, the screw will not properly engage the slots in the band. The instructions spell out how to be sure it is done properly. Also, note that the 'clamp' part is separate from the 'band' part. It is up to you to attach them together. Do it just as the directions tell you to, and you will have a very secure clamp. Do it wrong, and it can slip. Construction is good, and it is sturdy. I've used hundreds of hose clamps in my day, and this one is well above average in quality and strength. It is also 100% Stainless, so it should not rust. I carry a set, along with needle nosed pliers with a cutter and a screwdriver in my tool kit (along with the instructions). Has turned a 'I don't have a clamp that size' situation into a 'fixed it' situation more than once. Far easier to have one or two of these kits in the shop/toolbox than to have an inventory of lots of different sizes.

I will use it later

100% recommend

Not easy for beginners. Took me quiet a bit of time to set it up. Notice the video attached by the seller skips ahead, that’s where the hard part is. At one point i was hammering it to straighten out LoL.. once you set it up, it works great though..