Neoprene Rubber Strip with Adhesive, Solid Rolls & Strips for DIY Gaskets, Crafts, Pads, Flooring, Protection, Supports, Anti-Vibration, Anti-Slip (4'' Wide x 10' Long, 1/16)

It worked for what I needed it for

I used this to hide a gap between my wall and floor. It stuck well and was very flexible. It does however had an odor (kinda smells like tires) just so people know.

Applied this product to a mental table for traction against other metal parts. It's been on there for 4 months with no issues and provided the right about of protection without being too bulky

I have used this product before with great success. However this roll showed that the adhesive had interacted with the backing paper reducing the adhesive bonding qualities. I did apply it to clean metal, but have a couple hours bubbles were forming . I will request a replacement roll.stan Brown

The rubber is a quality material that works well to seal. But it doesn’t have any adhesive on it. For some reason I thought it would stick to a clean surface. I would have picked something else.

I got these strips to act as bearing surfaces for a sliding table I built for a tablesaw. The idea was to reduce vibrations and noise as the table moves on transfer bearings below it.I found the rubber to be sufficiently hard to move smoothly while damping the noise significantly. Also, the adhesive backing caught strongly and will presumably last long.

I am using these on a 1885 C20 Squarebody that I am replacing the entire fuel system. These are used as anti-squeak to protect from metal to metal contact really worked good.

Good and sticky worked great.