5 Pieces Tire Repair Kit, 1 Valve Core Removal Tool Tire Valve Stem Puller No Scratch Strength Blue Plastic Tire Valve Tool 4 TR412 Rubber Snap-in Black Tire Valve Stems for Standard Vehicle Tires

I like that the tool has a valve tool on one end, and a stem tool on the other.The tool is padded as to protect the rim, but the entire tool is not rigid, so there's less leverage.

good

I bought this tool so I can remove valve stem, and valve stem cores. Actually does more than that, it can also be used to punch out the center cap of the rims. I remove the core easily but not so much for the valve stem it’s self. When I use it for removing a valve stem the tools bends so it’s not very helpful, and it makes removing the valve stem hard. But that’s because the material it’s made out of. Would recommend a metal or fully plastic one. It hasn’t broke so I’m satisfied with it.

Not sure if this is intended JUST to pull a valve stem INTO a wheel that had not yet been seated, but there is no way it will pull a valve stem that is already seated in a wheel completely THROUGH the hole! I tried everything to get this tool to remove perfectly useable TR413 valve stems and had to resort to cutting the inside/larger diameter piece off, after which the stem simply falls out of the wheel. So this tool is completely useless if you're trying to salvage an otherwise good valve stem that is already mounted in a wheel. The cheap rubberized plastic this tool is made from bends and you can't get sufficient torque or leverage on the valve stem that you would be able to if the tool were made from proper high strength steel or a more expensive (i.e. titanium) metal/alloy.

So you can barely thread on the valve stems and you can barely pull the valve stems through without almost breaking the whole assembly. The valve core remover was cool, I liked that part but otherwise the rest is almost garbage. Sure in a last minute pinch, you could do this, but how often do you need to replace a valve stem from it leaking? Usually it’s just not bad enough to resort to this

These are for home use only! Light duty. When pulling valves these things are like a wet noodle. Bought 8 of them to use in a shop, they are all broken within a month. Very disappointing, forced to try these due to supply issues. Pins popped out, plastic broke and after a day of use they would develop a curve and be a pain to spin in your fingers.

A Little flimsy.. also the metal support rod the tire valve adapter swivels on bent with incredibly light pressure and doesn't swivel anymore. This is after trying to pull 1 valve stem thru. Valve stem was lubed generously with some amazing lube, so that wasn't the issue.

This is not a rigid handle. It flexes the moment you put pressure on it. This makes it very difficult to pull a valve stem out of the wheel OR to pull a new one through.