Eytool Clear Car Door Edge Protector,32Ft(10M) Car Edge Trim Rubber Seal Protector with U Shape Car Protection Door Edge Guard Fit for Most Car

I got this to try to protect the door edges of my new Model Y, as my garage is pretty cramped. I was concerned about how well it would adhere due to other reviews, but I took a chance since it's cheap. I also decided on this over door edge paint protection film since it is easier to apply and a lot thicker.Surprisingly, it's been several days and the edge guards are still perfectly adhered. Granted, I haven't driven much yet, but it's already an improvement over those who said it fell right off. I was pretty careful about the application, though. This was my process:1. With the film still on the adhesive, I fit the guard to the door and cut to length. Don't try to cut the guard directly on your door or you'll damage the paint!2. Not having isopropyl, I cleaned the door edge with Invisible Glass and paper towels, inside and out, making sure it was dry afterward.3. I peeled off a short length of the protective film covering the adhesive foam and started fitting it back on the door from top to bottom, slowly pulling the film away as I went. THE ADHESIVE GOES ON THE INSIDE OF THE DOOR! The adhesion wasn't super strong at first, so I had to hold the adhered portion with one hand while fitting a new section onto the door.4. While fitting, I made sure to pinch the door guard onto the door's front and back while also pressing it onto the edge -- if you just press onto the door edge parallel to the surface of the door, the adhesive won't stick well.5. Since my garage was cold (~40F), I then took a hairdryer on high temperature but low airflow and warmed the edge guard in sections ~4" long. I counted to ten before moving to heating the next section. While the next section heated, I would then use my other hand to again pinch the front and back of the door guard together to make sure the adhesive was stuck fast. I worked slowly like this from top to bottom.6. I repeated all of these steps on the next door.The Model Y front door edges are almost completely straight, but the back doors have a pretty sharp bend to go around the wheel wells. The edge guards buckled slightly at this location, but they are rubbery enough to not leave a gap. The white color is somewhat whiter than Tesla's white paint, but it doesn't look off-putting. I chose white rather than clear so that any dirt that may collect inside the guards won't show through.It has yet to be seen how durable these are in the long run, particularly in the rain or after extended UV exposure. I'll update the review if I notice any problems.Also, for what it's worth, the protective film on the adhesive foam layer was printed with the 3M logo. I hadn't seen any mention of that in the listing or other reviews, so it gave me a bit more confidence in the product.

I was unable to place on my car, couldn’t get it to stay on the car door. Returning

No instructions so took off 1 star. But figured it out. Went on fairly easily. (Put it in the sun for a while to warm it up and make a little more flexible, and moved the car to be in the sun while putting it on.) Been on for 2 weeks now. Looks good and no issues so far.

Putting this on my new car. The first two doors seem to be okay, then upon starting the third door, I noticed a dark gray residue stuck to the inside of the remaining roll of edge protector. It does not come off with the red tape (which apparently uncovers the adhesive when you pull it out.) So, the rest of the roll has the dark gray residue, which when applied to the door, looks like you have dirt under the "clear" edge guard. The stuff is a little stiff and takes some effort to get the open side to open enough to go over your door edge. Perhaps that helps it stay on. There were NO instructions included with this stuff. I did read some reviews in which the user outlined the steps he used. Really disappointed in this and am not going to use it on the remaining two doors. The gray crud is not easy to get off the inside of the guard either. "Clear" needs to pretty much disappear on my white doors, and it just looks like an edge of dirt. Worthless purchase.

I'm fairly impressed w/ this edging. I purchased a double order and was impressed that there was enough supplied to do both of my vehicles. The first is a small four door SUV so I knew there's be enough for it but my second vehicle is a 2500HD crew cab pick-up that's very large. There's not a natural belt line around the truck so in order to look right the edging had to run the entire height of the doors up to the roof. I easily had enough material for both vehicles and had around three feet (about a meter) left over.It's relatively easy to install with patience. The vehicle needs to be clean. I started at the top and slowly pressed the edging into place and then cut it to the right length at the bottom. After you are completely satisfied w/ the fit you pull it off at the top a little and pick at the red strip until there's enough to pull. Slowly pull out the red strip, moving down, and pressing the adhesive strip firmly against the inside of the door edge. One hint is to install it in fairly warm weather and I left the strip material in the sun as I was working with it so it would be soft and pliable. I had no trouble getting it to conform to shapes and it seems to be sticking well. I guess we'll see what happens in colder weather but I'm hoping that by then it'll be well attached. This edging isn't as thin and fancy as some I've seen applied by custom detailing shops, but for a do-it-yourself I think it's pretty good.The door edge on the SUV is a bit thinner than on the truck so the edging is slightly less flat but I don't think it looks bad. I've tried to show it in four pictures: three of it on the car and one on the truck.EDIT: I liked this so much I got another package of it to give to my grandson for his first vehicle.

It was easy enough to put on....in a couple weeks it started coming off the door.

Never wrote a review on a product from Amazon before but I had to on this one. I was very pleasantly surprised to see how small it was. I definitely didn’t want something as big as a garden hose to protect my door edges. It blends in perfectly with my white car and is practically unnoticeable. Time will tell how long it’ll last but for the price, if it lasts a year or so that’s fine I’ll get another one. Thanks!👍🏻

This item was returned. Wasn’t a good fit for my vehicle. The adhesive did not stick

Bought it to protect my doors edges in our very narrow garage. Worked really well. Easy to install. Not quite invisible, but pretty close. I bought two but even a single one was enough to do both of our cars.

Producto muy bueno y súper fácil de instalar, cumple con el objetivo, lo recomiendo

facile a installare e belle a vedersi.dopo 4 mesi si sta staccando la parte alta della portiera, ma ha fatto anche parecchio caldo

Somit kann ich neben meinem PKW parkende Autos nicht beschädigen, an der Türe angebracht!

Very easy to install, protects edge of the door from bumps.