Electrodepot Negative Ion Generator - High Voltage ionizer 7.5Kv Plasma Module 110-120 VAC

This ion generator performs exceptionally well. I can always get a steady stream of static ions flowing from the output just like it is supposed to. I use this product for mostly recreational and educational purposes, but I have also used it in conjunction with a chemical solution to speed up the decay of a razor blade. The blade was destroyed in less than a day. I can also use this electricity to put out a tiny fire, but not start one. Butane, propane, natural gas, and 91 percent isopropyl alcohol will not ignite from the spark under average circumstances. I have relit a zippo shortly after putting it out, but that hardly counts in my books. According to measurements I have taken at a lab in UTD, a direct flow from this (no spark, full contact) is about 340 volts of DC energy. This should only be seen as an energy translation, as the output is not AC or DC. The amperage was also measured at being about 100 nanoamperes. This is 10 million times less than what is necessary to stop a human heart, so even a failing one should be safe from this product.My only complaints are that you have to wire the source yourself, and the output ground wire failed on the first one of these I bought. This was after extensive use, and rough transportation. The static output is still functional, so it is more of an inconvenience than anything else.Only some plastic, rubber, and some glass are good enough insulators to stop this current. It is low power, but it can pierce nearly anything. Wood, flesh, paper, paint, bricks, ground, water, air... these can all conduct this energy, so if you have a giant metal table connected to the output, it will lose its charge seconds after being disconnected. It just leeches into the air and ground. Now I want to see what I can do with 5 or 10 of these.

Bought this to make an ionizer. It works well for that. While I wish the voltage was higher, when connected to a bronze 12 gauge bore brush as an emitter it produces a LOT of ions.If it had had a wiring diagram to identify the wires, it would have gotten 5 stars.If you wanna make an ionizer on the cheap, then this is the module for you.

I read lots of reviews and looked for a long time before getting this ion generator. After it arrived I triple checked and quadruple checked the connections before powering it up. I powered it up and - nothing. It's just a lump of epoxy with four wire legs on it. I've been lucky in the past but not this time.Can someone from the seller get in touch with me?Thanks.

This is a neat little gadget. I am using it to power an arc screen for generating O2 that formerly used an oil burner ignition transformer. It does the job and does not flood the place with excess O2. Quite happy with it.A lead diagram would have been helpful,

Works as expected. Now I'll have to build it into a proper structure. I would like a higher ion rate but that's not a fault of the unit. Next time I'll get one that's more powerful, but this is adequate.

This worked very well in my new static grass applicator that i built from instructions on U tube !!

Used it to build a static grass applicator. Works great. Lots of power.

I lost the directions and it’s hard to figure out without it