LycoGear Universal Ham CB Radio Microphone Mic Hanger Holder Mount with Adhesive Back, Pre Drill Holes & Single T Tab Connection, KLP-X2

Worked well for my mic relocation. I have a Std Hor vhf. This fit just fine, not sloppy, or too tight. Install too 15mins. Tip; Use the adhesive patch to hold it while you drill out the mount holes if needed. This uses #4 stainless steel screws (2). As that's the hole size.

Worked really well to hold my mike.

This is the first change in microphone clips in 50 years! I'm planning to order more. Pros: It is usable with most portable radios The depth gives a small offset to bring the clip forward from other flat surfaces and improves access Cons: I have not found any adhesives which will hold fast on vertical surfaces during high in car temperatures (I use a small screw for attachment) The clip does not fit all microphones due the thicker material as opposed to metal clips Some commercial radios rely on contact with metal at the mic clip to allow radio features to function properly (Motorola)

I've had this installed for about a month now. So far so good. Good construction, tape is holding well. Holds my microphone to my ftm-300 great. This is a great value.

This microphone hanger is perfect for mobile use. The adhesive stays put and it’s very well made. Easy install. Remember to let it sit overnight after you install it but before you use it. No issues with this at all.

It fit my any tone 5888 uv mic just fine but it would not stick to my Dash even after giving it a really good cleaning with the alcohol not about the drill holes in my new cars dash . It's residing very comfortably in the garbage can now. Unless you plan to mount it with screws don't bother what a waste of money.

Was really hoping this would be a perfect clip for my mic in my truck, but the plastic is way too thick for the Heil HMM's round bracket on the back. I made it work by using the belt sander and taking off a healthy portion of the bracket's face, and with a little coating of silicone oil it slides in well and the "springy things" work quite well. This unit could also have been made much thinner overall, as it protrudes almost a full inch, and I see no need for it being this large at all. In all of the mics I've had over the years (since 1975), they would all have fit this well without it protruding any more than 3/8". I can only assume its this large because of the molding process. Anyways, it now works, and with some cleaning with isopropyl alcohol on the clip and my vehicle's plastic interior panel, as well as a light coating of 3M's tape primer that I have for signs and other vinyl work I do, I doubt this will ever come off unless I really want it to.

It works just fine. Easy install and inexpensive. It looks great and now I have a place for my mic. I didn't use the "3m" double sided tape that it came with because who knows how long that'll last so I used my own 30lbs adhesive tape.