Frienda6 Pieces 2-4 Gauge 175A Battery Quick Connector 12-36V Battery Quick Disconnect Wire Harness Plug Kit Battery Quick Connector Disconnect Plug for Motor Winch Trailer (Grey)

these are not for the weekend DIY guy.they work well, you will need to know what your doing to build these, recommend soldering the connections after crimping, do not recommend using the rubber boot as it will trap and hold water then cause corrosion

This is for the Red Frienda 3 pack of 175a connectors and contains rubber covers. The red plastic housings are labeled JNCK Power Products SJ 175A-600V. The metal connectors will snugly fit 1/0 welding cable even though description says 2-4ga. It's a bit big, I doubled over the factory 6ga wire on the device and used some 6 ga also doubled over and crimped in there which worked ok. These are way overkill for my 12v 85A load, but that's ok bigger is better. Yes I know the device is using too small of wire...I cut the wires about 12" and installed this plug there. MY wiring will be much larger.They went together pretty well and crimped down with a heavy duty Hydraulic crimper die size of 35. You WILL need something similar. Some say solder, but that can also cause problems with creating a breaking point of the wire and cold solder joints. I also recommend using Dielectric Grease on the contacts to maintain minimal corrosion for years.If your cable is twin, make sure to crimp so both blades are facing the same direction so the wire will lay in connector nice and flat. As well as make sure the flat sides of crimp are sideways or on the same plane as the flat of metal connector to fit better in the connector.

Came well packaged and far exceeded my expectations. Good quality an heavy duty.

These are great ways to add a quick disconnect to any power supply that has 2-6gage wires. I use them for the power supply on my car trailers wench, and they hold together great.

Great connectors. Easy to crimp. Work well. The rubber covers suck. I prefer the plastic covers instead

The media could not be loaded. These connectors were much cheaper than my local auto parts store. I’m using them to connect to a pump motor on a snow plow backblade. I used solder in the connections to keep them from corroding.

Nice Product!

I used these to connect battery power to a winch on a flatbed trailer. Since the trailer disconnects from the tow vehicle, these leads need to a well. They are heavy duty and work well - just need to be sure the connecting lugs are seated properly or the connection won't be made, even though it looks like the plastic parts of the plug are together.